Text preview for : 4726.pdf part of Braun Oral Line Outline and explosion device, service manual and catalog
Back to : Braun_Oral_Line_Carioquen | Home
Service Documentation Braun Oral- B Plak Control
Market Release 11/94
D5
4726
4726
BINC Rev: 4/98 BAG Rev: 12/97
Service Documentation
Exploded Drawing 4726
4726 - 2
BINC Rev: 4/98 BAG Rev: 12/97
Service Documentation
Spare Parts List 4726 Part Description
Lid Spring catch Spring Brush container Housing Trickle charger Handle without timer Handle with timer Switching plate Brush, single pack Brush, 3 pack Wall attachment Housing for trickle charger
Pos. No.
1 2 3 4 5 6 7 7 8 9 9 10 12
Part Number
4726052 4726057 4726058 4726051 4726233 4726632 4726630 4726631 4726860 EBI 9 /1 EBI 9 /3 4726054 NLA
4726 - 3
BINC Rev: 4/98 BAG Rev: 12/97
Service Documentation
Service Information 4726
Technical Data Voltage Frequency Power input approx. Appliance: 100 - 120 V 50 - 60 Hz 1 Watt Plastic, heat sealed 2.4 V - DC - motor The transmission of power follows by way of gear train with excenter to the shaft of the brush. 2 built-in batteries which can be recharged by inductive continuous operating charger. (without contact). It compensates the loss of charge in the daily use-continuous charging. No danger of overloading. Signal by a green LED (light emitting diode). Multituft Oscillation ring brush movements approx. 70 ° Magnetic reed switch, watertight Length without brush 18.5 cm, diameter 3.2 cm. Height 17 cm, length 4.65 cm, width 9.0 cm. approx. 45 minutes when unit was fully charged. is equipped with an optical 2-minute timer, indicated by a red LED. When the capacity of the cells is running empty the power unit fails to function immediately. This protects the rechargeable cells from deep discharging. This maintains the motors full power capacity, The power unit should always be stored in the plugged in charging unit after use. The empty capacity is not comparable to a defective power unit. 4726 - 4
Power supply:
Charger, continuous operating:
Brushes: Brush function: Angle of oscillation: Switch: Dimensions of the unit: Dimensions or the charger. Operating time: Plak control timer only: Indication:
BINC Rev: 4/98 BAG Rev: 12/97
Service Documentation
Service Information 4726
Cell-Pack Recycling of Braun-Plak Control At the end of the time-of-use of this product, for environmental protection, the nickel/cadmium(NC)-cell pack must be correctly recycled. For this purpose, the following steps are necessary: · Put appliance including lower cap into the opening (located in the back of the charger) and break-off lower cap (see illustration).
·
By applying pressure to the motor shaft, push cell pack with motor assembly out of housing and tear-off both thin connecting wires. Break-off cell pack with PCB from motor and remove the remaining part of the PCB from the cell pack. Remove cell pack out of plastic tube and dispose cells according to local laws or applicable environmental regulations for correct material separation and recycling. The cells must never be thrown into fire or flame.
·
·
Attention: This product contains nickel-cadmium cells. In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of their useful life. Disposal can take place at appropriate collection sites provided in your country. This product conforms to the EMC-Requirements as laid down by the Council Directive 89/336/EEC. 4726 - 5