Text preview for : 4729.pdf part of Braun Oral Line Outline and explosion device, service manual and catalog
Back to : Braun_Oral_Line_Carioquen | Home
Service Documentation Braun Oral-B 3D Plaque Remover
Market Release 8/98
D 15525 D 15525X
4729
4729
BINC Rev: 8/98 BAG Rev: 3/98
Service Documentation
Exploded Drawing 4729
4729 - 2
BINC Rev: 8/98 BAG Rev: 3/98
Service Documentation
Spare Parts List 4729 Part Description
Appliance (15525) Appliance two speed (15525X) Brush Trickle charger tower Brush container Wall attachment
Pos. No.
1 1 2 3 4 5
Part Number
4729630 4729635 EB 15 4729649 4729640 4729052
4729 - 3
BINC Rev: 8/98 BAG Rev: 3/98
Service Documentation
Service Information 4729
Technical Data Voltage: Frequency: Power input: Appliance: 100 - 130 V 50 - 60 c/s approx. 2 Watts Plastic heat sealed. 1.2 V-DC-motor. The transmission of power follows by way of gear train with excenter to the shaft of the brush. 2 built-in batteries, which can be recharged by inductive continuous operating charger (without contact). It compensates the loss of charge in the daily use. Continuous charging. No danger of overloading. Signal by a green LED (light emitting diode). Multituft Oscillating brush movements 3800/min. approx. 56° Pressure switch watertight. The deluxe model features a reduced speed setting for sensitive areas of the mouth. Length without brush 19.0 cm, length 2.5 cm width 3.5 cm. Height 17.3 cm, length 4.8 cm, width 10.5 cm. Height 17.3 cm, length 4.8 cm, width 10.5 cm. approx. 30 minutes when unit was fully charged. After two minutes of operation the timer signals. The brush will turn off and at short intervals during a period of approx. 2 seconds. You can hear and feel that the minimum 2-minutes brushing time is over. An incorporated timer memorizes the elapsed brushing time, even when the handle is briefly (max. 30 seconds) switched off. 4729 - 4
Power supply:
Charger, continuous operation:
Brushes: Brush function: Angle of oscillation: Switch:
Dimensions of the unit: Dimensions of the charger: D 15525 D 15525X Operating time: Stop and go timer:
BINC Rev: 8/98 BAG Rev: 3/98
Service Documentation
Service Information 4729
Preserving the rechargeable batteries After 16 hours the handle is fully charged. 30 minutes of operation time. To maintain your plaque remover's full power capacity, the handle should always be stored on the plugged in charging unit. Overcharging is impossible. Cell-Pack Recycling At the end of the time-of-use of this product, for environmental protection, the nickel hydride NH cell pack must be correctly recycled. For this purpose, the following steps are necessary: · · Open the bottom of the handle as shown, (see illustration) By applying pressure to the motor shaft, push cell pack with motor assembly out of the housing and tear off both thin connecting wires. Remove the battery and dispose of according to the local environmental regulations. The cells must never be thrown into fire or flame.
·
Attention This product contains nickel hydride cells. In the interest of protecting the environment, please do not dispose of the cells in the household waste at the end of their useful life. Disposal can take place at appropriate collection sites provided in your country.
This product conforms to the EMC requirements as laid down by Council Directive 89/336/EEC.
4729 - 5