Text preview for : 5524.pdf part of Braun Shave Line Outline and explosion device, service manual and catalog Part3
Back to : Braun Shaver.part3.rar | Home
Service Documentation Braun pocket battery deluxe
Market Release 2/90
5524
5524
BINC Rev: 7/96 BAG Rev: 2/90
Service Documentation
Exploded Drawing 5524
5524 - 2
BINC Rev: 7/96 BAG Rev: 7/95
Service Documentation
Spare Parts List 5524 Part Description
Cleaning brush Protective cap Shaving head frame Shaving foil Cutter block Circlip Cutter block support, w/pos. no 8 Conical coil spring Oscillating frame Eccentric Motor Switch handle Housing, upper part Housing, lower part Spring Spring catch Battery cover
Pos. No.
1 2 3 4 5 6 7 9 10 11 12 13 14 15 16 17 18
Part Number
5524804 5524802 5523624 5524764 5524761 0107001 5523812 5523042 5523510 5523807 5523626 5523034 5524611 5524629 5523018 5523016 5524096
5524 - 3
BINC Rev: 7/96 BAG Rev: 2/90
Service Documentation
Service Information 5524
Description of shaver Battery shaver Housing: Shaving head frame: Shaving foil: Cutter block: Protective cap: for pocket battery: for pocket deluxe: Plastic Plastic 40 mm wide, removable (snap connection) 30 cutter blades, 3° obliquely positioned, 10 mm diameter, plastic removal with clamp for cleaning brush swivel protective cap integrated in the unit with locking.
General Information Drive: Power supply: 2.7 V direct-current motor. Power transmission to cutter block by means of eccentric and plastic oscillating frame. Supply by means two 1.5 V Mignon cells (type LR6/AM3/ MN 1500/AA alkaline).
Technical data 1 Amplitude at the cutter block: approx. 2.4 min. 2. Rotational speed: approx. 6200 r.p.m. 3. Operating current: approx. 500 mA 4. Operating capacity: approx. 60 shaving minutes
5524 - 4
BINC Rev: 7/96 BAG Rev: 2/90
Service Documentation
Service Information 5524
Disassembly · · · · · · Remove batteries, take off cutting parts. Disassemble cutter block support with rubber seal. The housing halves are held together by snap-action. Apply pressure diagonally on sides of housing and squeeze, until parts disengage. Start at battery well to separate housing parts. Attention! Spring (16) and catch (17) will jump out of housing parts, also the battery cover (18) will drop out. Motor (12) with oscillating frame (10) can now be removed from housing, lower part (15).
Assembly The assembly will be accomplished in a reversed sequence. Attention should be paid to the following points: · · · · · The motor (12) must be installed with correct polarity. The minus-pole of the motor (the motor contact which is not soldered), must be pinched between the battery contact. Insert oscillating frame (10) in such away, to line-up with the upper edge of the housing. First engage housing halves on the upper side, put battery cover (18) into place at the bottom, then press both parts together. Assemble cutter block support (7) and pull rubber seal (8) over bead on housing. After housing has been assembled, slide spring catch (17) with spring (16) into the pockets
Insert batteries, carry out functional tests.
5524 - 5