Text preview for : 81204309.pdf part of panasonic cs-g123ke i have some code indicated F99 and the air conditioning stop
i think this might be same model,it shows the fault codes at the end i think
Back to : PANASONIC CS-G93KE_PDF SE | Home
CS-G93KE
Installation Information
Attached accessories
No. Accessories part Installation plate Qty. No. Accessories part Drain elbow Qty.
1
Installation plate fixing screw
1 6 6
Remote control
1
Band
2 3 4 5
Air purifying filter
7
1
Vinyl tape
1 8 2
9
3
Vinyl tape
Battery
1
2
Accessories: Flaring piping kit CZ-3F5, 7AEN (CS-G93KE) CZ-4F5, 7AEN (CS-G123KE) SELECT THE BEST LOCATION INDOOR UNIT · · · · · · · · There should not be any heat source or steam near the unit. There should not be any obstacles blocking the air circulation. A place where air circulation in the room is good. A place where drainage can be easily done. A place where noise prevention is taken into consideration. Do not install the unit near the door way. Ensure the spaces indicated by arrows from the wall, ceiling, fence or other obstacles. Indoor unit of this room air conditioner shall be installed on the wall in a height of at least 2.3 m. OUTDOOR UNIT · · · There should not be any animal or plant which could be affected by hot air discharged. Keep the spaces indicated by arrows from wall, ceiling, fence or other obstacles. Do not place any obstacles which may cause a short circuit of the discharged air.
Piping size MODEL Gas G93KE G123KE 3/8" 1/2" Liquid 1/4" 1/4" 5 5 Rated Length
Max. Elevation (m) 5 5
Max. Piping Length (m) 7 7
48
CS-G93KE
Installation Information
Indoor / Outdoor unit installation diagram
Length of power supply cord about 1.1 m
< <
Piping direction Right Right rear Left Right bottom rear (Front side) Left Left bottom
Attention not to bend up drain hose
about 1.8 m
< <
Installation parts you must purchase (*)
5 cm or more
Installation plate 1 Sleeve (*) Bushing-Sleeve (*)
POWER SLEEP TIMER
Putty, (Gum Type Sealer) (*)
UL
ECONOM
Y
POWERF
5 cm or more
Air purifying filter 5
Bend the pipe as closely on the wall as possible, but be careful that it doesn't break.
(Left and right are identical) Insulation of piping connections
· · Carry out installation after checking for gas leaks. After securing with three of the vinyl tape 8, wrap with vinyl tape 9.
Vinyl tape 9 Vinyl tape 8
Vinyl tape (Wide) (*) · Apply after carrying out a drainage test. · To carry out the drainage test, remove into the heat exchanger. To carry out the drainage test, remove into the heat exchanger.
Saddle (*)
cm 10 ore m or
Connecting cable (4-CORE WIRE/1.5 mm2) Locally approved cable. Additional drain hose (*)
10 cm or mor e
1/4" Liquid side piping (*)
cm 100 ore or m
Gas side piping (*) 3/8" (G93KE) 1/2" (G123KE)
· This illustration is for explanation purposes only. The indoor unit will actually face a different way.
49