Text preview for : Protek6502_probe.pdf part of ProTek 6502 ProTek CRO - Model 6502
Covers 20, 40 and 60Mhz.
ProTek brand is also known as Hung Chang
Back to : ProTek_CRO_6502_All_Manua | Home
Instructions /1///;////;1/////////////////////1/1///// //// //1///////// ///I///;;
TP6100 100MHz TP6060 20/40/60MHz X1&X10 Passive Probe
Specifications
These characteristics apply to a TP6000 series probe installea
on a specified oscilloscope.When used with another instrument, the oscilloscope must have an input impedance of 1 M ~2. The instrument must have a warm-up period of at least 20 minutes and be in an environment that does not exceed the limits.
Item
;tienuation
input Hesistancc
TP6060
Xi, Xto
TP6100
1MOħ2%(x1): 1OMOħ2%(x10)
~nput
Capacitance Compensation Range System Bandwidth Maximum Working Input Voltage Net Weight Cable length Temperature Operating Non operating Humidity
Xi: 85pF-115pF X10: 18.5pF-22.5pF
X1: 85pF-1i5pF X10: 14.5pF-17,5pF
All OSCILL OSCOPES
DC-4MHz DC-60MHz X1: <150VDC+Peak X10: <400VDC+Peak
DC-6MHz DC-100MHz AC AC
<55g 120cm
JO'(
'50"('
20"C ,,8~%
'7S'(
(Relative Humidity!
Maintenance
Low-Frequency probe Compensation
Before taking any measurements using a probe,first check the compensation of the probe and adjust it to match the channel i:lputs.Most oscilloscopes have a square wave reference signal available at a terminal on the front panel used to compensatethe probe.Connect the probe to the signal source to display a1KHz test signal on your oscilloscope. Set the probe to X10 position.
Adjust trimmer L until seeing flat-top square wave on the display.
Maximum Working Voltage Derating Curve
500V
(VDC+Peak AC)
200V
~
i!
o
I ~
1MHT
10MH>:
100MH>:
TP6000 Series Probe Assembly Drawing
Part Exposition:
1. Probe Rod 2. Probe Tip 3. Ground Lead 4. Marker Ring 5.Tip Locating Sleeve 6. Adjustment Tool
Hote' Contents of this document are subject to change without notim.