Text preview for : Compaq MV540 CQ550F CO1075 case.pdf part of Compaq mv540 Compaq MV540, CQ550F, CO1075
Back to : Compaq MV540 CQ550F CO107 | Home
1. SPEAKER REMOVAL 1) Upward the a in arrow(a) and pulling the Speaker in arrow(b). 2) Remove Speaker from the Monitor.
2. TILT/SWIVEL REMOVAL 1) Set the monitor face downward. 2) Pressing the latch (a), carefully remove the Tilt/Swivel by pulling it upward.
(a)
(a)
(a)
(b)
(b)
MV540
3. TOTAL CHASSIS ASSEMBLY REMOVAL 1) Remove connector (a) from the DY Assembly screw. 2) Carefully separate the CDT Board Assembly from the CDT neck. 3) Discharge the remaining static electricity by shorting between the Anode Cap and the CDT ground. 4) Disconnect the Anode Cap from the CDT. 5) Disconnect three connects (c). 6) Disconnect P902 (Degaussing pin), P701(DY pin), and P405, P202 from the Main PCB. 7) Remove two screws (b). 8) Remove the Total Chassis Assembly from the Cabinet.
(a)
Anode Cap
(c)
DY ASSEMBLY SCREW
P701 (DY PIN) P202 MIC
(c)
P701
P902 (DEGAUSSING COIL)
(b)
P202 P902 P405 P402
P201 (Control PCB)
(b)
4. VIDEO PCB ASSEMBLY REMOVAL 1) Disconnect P301, P302, G2 from the Video PCB. 2) Disconnect three connects (a). 3) Remove the screws (b). 3) Remove the Video PCB Assembly.
6. BOTTOM BRACKET REMOVAL 1) Remove three Holders (a). 2) Remove four screws (b). 3) Remove the Bottom Bracket.
(b) (b)
(a)
P302 G2 P301
(b)
(b)
(a) (b) (a)
(a)
(a)
(a)
5. CONTROL PCB & MICRO PHONE ASSEMBLY REMOVAL 1) Remove three screws (a). 2) Remove the Control PCB Assembly from the Front Cabinet. 3) Remove two screws (b) 4) Remove the Micro phone Assembly (b) from the Front Cabinet.
(b)
(a) (a) (a)
- 11 -