Text preview for : README.TXT part of Fujitsu-Siemens 383v FA Fujitsu-Siemens 383v FA (15 coll) TFT Monitor
Back to : Fujitsu-Siemens 383v FA | Home
Adjustment Programm for 383V FA
===================================
1. Introduction
Analog flat screen monitors such as the 383V FA must be adapted to the
screen controller for each used screen resolution and refresh rate.
The program LCDADJ.EXE generates the test pattern required for precise
calibration.
2. Preparation
Select the screen mode to adjust (e.g. under Windows 9x via
Start - Settings - Control Panel - Display - Settings).
Further information is provided in the operating manual of the monitor.
Allow the unit to warm up for approx.. 20 minutes prior to calibration.
3. Installing of the driver
Plug & Play operating systems (Windows 9x / ME / 2000 and XP) ask for a
driver after connecting the flat screen monitor to the PC and reboot.
Please follow the instructions of the operating system. On other
operating systems please select the screen mode manually.
The optimal resolution for this screen is 1024x768 and the optimal
refresh rate is 60Hz.
4. Calibration
Start the program LCDADJ.EXE.
The auto adjustment could be performed by the OSD. In most cases
the result of the auto adjustment is OK.
In seldom cases it is necessary to optimize the image manually:
Setting window Option Function
-------------------------------------------------------------------
1) AUTO-Contrast
2) LCD ADJUST H-SIZE eliminate vertical picture interference
3) LCD ADJUST FINE TUNE improve focus
4) LCD ADJUST H.Position
5) LCD ADJUST V.Position
6) Brightness
In seldom cases a vertical refresh rate higher than 60 Hz would improve
the picture.
5. Any problem or other question you need clarified?
Please contact one of our IT Service Shops or your local sales partner
or office for advice.