Text preview for : 5_09.pdf part of Panasonic VDR-M70 Panasonic VDR-M50 and VDR-M70 Service manual
Back to : Vdr-M50_M70.part1.rar | Home
(9) Disc Cover
1) Remove the space sheet (b) that covers the opening for operating lock arm. 2) Use a fine-tipped flat-bladed screwdriver to move the lock arm (d) in the direction of the arrow to open the disc cover (a). 3) Disconnect the one flat cable. 4) Open the card slot cover (g). 5) Remove four screws [F]. 6) Remove the disc cover in the direction of the arrow: Be careful not to damage the flat cable (h) that extends from the disc cover. Procedure and caution for reassembly 1) Reinstall the disc cover so that the hinge 1 of side case-R fits into portion 2 at the inside top of disc cover, and that the cover is not inclined. Installing and inclined disc cover could damage the switch inside the disc cover. 2) Pass the flat cable extending from the disc cover through the gap between the frame and side case-R, and then connect it to the MAN-H/MAN circuit board (f).
(a) (b) (c) (d) (e) (f) (g)
Disc cover Space sheet Opening for operating lock arm Lock arm AEL-H/AEL circuit board MAN-H/MAN circuit board Card slot cover
(h) Flat cable (i) Hinge of side case-R (j) Frame (k) Side case-R (m)Loader (n) Disc drive unit
(a)
1) (b)
(d)
(c)
2)
(c) (e)
(i)
2 (f) 1
(h)
6)
(a)
3)
(1) (2) (1) (1)Unloc (2)Pull k
4) (g)
Fig. 5-3-11 Left Side
[F] M1.6x2.5 (Black)
Correct 5) [F] 5) [F]
Incorrect
Incorrect
(j) (f) (h)
(n) (m) (i) (a) (k)
Installing and inclined disc cover could damage the switch in side the disc cover.
Disc cover
Switch
Fig. 5-3-12 Right Side