Text preview for : 6_07.pdf part of Panasonic VDR-M70 Panasonic VDR-M50 and VDR-M70 Service manual
Back to : Vdr-M50_M70.part1.rar | Home
4) Choose the communication port to which the RS-232C cable is connected, and then choose the radio button of corresponding port on COMMUNICATION PORT SETTING screen. 5) Click the OK button on the COMMUNICATION PORT SETTING screen, and then proceed with the MODEL SELECT screen. Note: If the following dialogs appear, perform the troubleshooting below:
POWER OR CONNECTION ERROR dialog
ERROR
COMMUNICATION PORT SETTING screen
MANUAL ADJUSTMENT PROGRAM for SERVICE STATION
MANUAL ADJUSTMENT PROGRAM
for SERVICE STATION
COM PORT SETTING
PORT PORT 1 PORT 4 PORT 5 PORT 6
4
PORT 2 PORT 3
5
OK
EXIT
!
MAY OCCURE ON CABLE OR JIG OR CAMCORDER. POWER FAILURE OR CONNECTION ERROR!
OK
Copyright (C) HITACHI, Ltd 2003
COM PORT ERROR dialog
ERROR
!
COM PORT ERROR
OK
When the power or connection error dialog appears: A connection is incorrect or power is not turned on. Make sure that all connections are correct and that power is supplied to the reference data creating device or DSP-R interface jig. Clicking the OK button will finish the program: After solving the problem, restart the program. When the communication port error dialog appears: There was a mistake in selecting communication port. Check the communication port. Clicking the OK button will finish the program: Select the communication port again after restart.