Text preview for : 8050_installation.pdf part of lg wd-1050f servise manual wd-1050f
Back to : wd-1050f.rar | Home
4. INSTALLATION
¢ Before servicing ask troubles of customers ¢ Check the adjustment(power supply is 220-240V, remove the transit bolts....) ¢LCheck the troubles referring to the trouble shooting. ¢ØDecide service steps referring to disassembly instructions. ¢OEAnd then, service and repair. ¢ºAfter servicing, operate the appliance whether it works O K or NOT. ¡/
¡ÆSTANDARD INSTALLATION
The appliance should be installed as follows.
REMOVE THE TRANSIT BOLTS
URemove the transit bolts (4EA:€ )with supplied spanner. UKeep the transit bolts and spanner for future use.
INSTALL THE APPLIANCE ON FLAT AND FIRM SURFACE
ADJUST THE HORIZONTAL
UTurn the leveling feet to set the appliance horizontally.
Low High
UThe appliance goes up by rotating the feet clockwise. UThe appliance come down by rotating the feet counter clockwise.
1
7
¡Æ HOW TO CONNECT INLET HOSE
UCheck that the rubber packing is inside of the valve connector. UConnect the inlet hose firmly to prevent leak.
¡ÆCONNECT DRAIN HOSE
¡/Make sure that the hose is not twisted.
¡/Avoid submerging the end of the hose.
¡ The drain hose should be placed under 85§flfrom the floor. ¡ÆCONNECT POWER PLUG
¡/Connect the power plug to the wall outlet.
¡/Avoid connecting several electric devices, It may be the cause of the fire.
8
£GTEST OPERATION
Preparation for washing. Press the power button. Press the START/PAUSE button.
U Connect the power plug to the outlet. U Connect the inlet hose.
U case of Coloreds program. In
Check the water heating.
Check automatic reverse turn.
Check the water supply.
¡/ Press the button TEMP¡B ¡A and the present temperature will be displayed. ¡a WD-1050F(H)/1250F(H)¡b
¡/ Check if the drum rotates clockwise and counterclockwise.
¡/ Check if water is supplied through the detergent dispenser.
Check drain and spin
¡/ Turn off Wash and Rinse after pressing the Start/Pause button and start the machine again. ¡/ Check drain and Spin.
Power off and open the door
Water removal
¡/ Power off and then power on. ¡/ Check if the door can be opened after Door Lock lamp turns off.
¡/ SVC is needed during If check, remove the remaining water by pulling out the hose cap.
9