Text preview for : 255_259IIX_Ch5_Installation_Guidelines.pdf part of Optima Centoris W259 Series Optima Centoris W259 Series Service Manual
Back to : Centoris W259 Series Serv | Home
Chapter 5
Installation Guidelines
255/259IIX
Rev. A
Page 1
Chapter 5
Installation Guidelines
5.1. CPU, RAM, HDD Installation................................................... 5.2. Upgrade System & Keyboard BIOS.............................................
3 8
255/259IIX
Rev. A
Page 2
Chapter 5
Installation Guidelines
5.1. CPU, RAM, HDD Installation Warning Notice
For precautionary measures, please disconnect the AC adapter and remove the battery from the battery compartment while doing the installation procedure of the CPU, Memory & HDD. Procedure to remove the battery
Unlock the battery knob and pull out the battery pack.
A. CPU Installation Guide
Important Notice
The CPU thermal pad of the CPU fan heat sink (black color) is one time use only. Meaning that if you remove the CPU heat sink from the CPU, you must REPLACE the CPU thermal pad with a new thermal pad (black color). Clean any residue on the CPU and the CPU heat sink assembly before putting the new CPU thermal pad. Otherwise, there might be an overheat problem on the CPU.
1.Unfasten 6 screws and remove the CPU and DDR cover.
255/259IIX
Rev. A
Page 3
Chapter 5
Installation Guidelines
2.Unfasten 3 screws from CPU Fan cover and disconnect Fan cable from the connector.
3. Align the pin 1 of CPU with pin 1 of CPU socket and gently put the CPU into the CPU socket.
4. Fasten the CPU Lock clockwise.
255/259IIX
Rev. A
Page 4
Chapter 5
Installation Guidelines
5. Fasten 3 screws from CPU Fan cover and connect Fan cable from the connector.
6. Put CPU and DDR cover then fasten 6 screws.
255/259IIX
Rev. A
Page 5
Chapter 5
Installation Guidelines
B. HDD Installation Guide
1. Fasten 4 screws of HDD module.
2. Unfasten 1 screw of the HDD cover.
3. Push the HDD casing into the HDD connector.
255/259IIX
Rev. A
Page 6
Chapter 5
Installation Guidelines
4. Fasten 1 screw of the HDD cover.
255/259IIX
Rev. A
Page 7
Chapter 5
Installation Guidelines
C. DDR Module Installation Guide.
1. Unfasten 6 srews of the CPU and DDR cover.
2. Put the DDR Module to the DDR socket.
3. Fasten 6 srews of the CPU and DDR cover.
255/259IIX
Rev. A
Page 8
Chapter 5
Installation Guidelines
5.2. Upgrade the BIOS Important Notice
The utility only support at real mode (DOS mode), can not run at the protected mode (Window Mode). Do make sure that the system boot from real mode and plug AC power when to update the BIOS or install the utility. BIOS Update Procedure The F82745EXE utility is used to flash the system ROM and upgrade the BIOS. 1. Make sure the AC adapter is connected to your notebook before you run this utility. 2. Please make a clean Boot Disk which has no config.sys and autoexec.bat files. 3. Boot from Floppy disk, enter DOS prompt. 4. Type DIR 5. Please make sure the diskette has the following files : F82745EXE and xxxx.xxx (Bios Filename) 6. Start to update the system BIOS, AC power must plug into unit. Type A:\F82745 xxxx.xxx 7. Press Enter. After updating the bios, please go to BIOS setup and load DEFAULT setting. The system reboots automatically after installation is complete.
255/259IIX
Rev. A
Page 9