Text preview for : Disassembly & Reassembly.pdf part of Samsung 910MP SM
Back to : Samsung SyncMaster 910MP. | Home
3 Disassembly and Reassembly
3 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the MZ19FS LCD Monitor.
!
WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling these components.
3-1 Disassembly
!
Cautions: 1. Disconnect the monitor from the power source before disassembly. 2. When IP-BOARD has a defect, the whole PCB ASS'Y, not a single part, should be replaced. 3. R/Cover opening jig : BH81-00001A 1. Place monitor face down on cushioned table. Remove 4 screws from grip on the stand. Remove the rear cover by using opening.
2. Remove rear cover from the monitor. Remove 2 screws from the main shield.
3. Remove 6 screws from the main shield cover. Disconnect speaker cable and function cable.
4. Lift up the shield cover. Disconnect inverter cables, LVDS cable from the main board.
5. Lift up the board. This picture is the panel
3-1
3 Disassembly and Reassembly
3-2 Reassembly
Reassembly procedures are in the reverse order of disassembly procedures.
3-2