Text preview for : Boss CH650.pdf part of Boss CH650 Boss Amp CH650



Back to : Boss CH650.pdf | Home

MODEL: CH650

SPECIFICATIONS
Maximum power output (2 Ohms): 250W x 4ch RMS power Output: 100W x 4ch Bridged Power Output: 500W x 2ch Frequency response: 9 - 50KHz Harmonic distortion: 0.01% S/N Ratio: 130dB Power Source Voltage: 14.4V Ground: Negative Power consumption: 25A(with 125Wx2 rated output) External dimensions: 300(W)x65(H)x378(D)mm
-1-

To engineers in charge of repair or inspection of our products.
Before repair or inspection, make sure to follow the instructions so that customers and Engineers in charge of repair or inspection can avoid suffering any risk or injury. 1. Use specified parts. The system uses parts with special safety features against fire and voltage. Use only parts with equivalent characteristics when replacing them. The use of unspecified parts shall be regarded as remodeling for which we shall not be liable. The onus of product liability (PL) shall not be our responsibility in cases where an accident or failure is as a result of unspecified parts being used. 2. Place the parts and wiring back in their original positions after replacement or re-wiring. For proper circuit construction, use of insulation tubes, bonding, gaps to PCB, etc, is involved. The wiring connection and routing to the PWB are specially planned using clamps to keep away from heated and high voltage parts. Ensure that they are placed back in their original positions after repair or inspection. If extended damage is caused due to negligence during repair, the legal responsibility shall be with the repairing company. 3. Check for safety after repair. Check that the screws, parts and wires are put back securely in their original position after repair. Ensure for safety reasons there is no possibility of secondary ploblems around the repaired spots. If extended damage is caused due to negligence of repair, the legal responsibility shall be with the repairing company. 4. Caution in removal and making wiring connection to the parts for the automobile. Disconnect the battery terminal after turning the ignition key off. If wrong wiring connections are made with the battery connected, a short circuit and/or fire may occur. If extensive damage is caused due to negligence of repair, the legal responsibility shall be with the repairing company. 5. Cautions regarding chips. Do not reuse removed chips even when no abnormality is observed in their appearance. Always replace them with new ones. (The chip parts include resistors, capacitors, diodes, transistors, etc). The negative pole of tantalum capacitors is highly susceptible to heat, so use special care when replacing them and check the operation afterwards. 6. Cautions in handling flexible PCB Before working with a soldering iron, make sure that the iron tip temperature is around 270... Take care not to apply the iron tip repeatedly(more than three times) to the same patterns. Also take care not to apply the tip with force. 7. Turn the unit OFF during disassembly and parts replacement. Recheck all work before you apply power to the unit.

-2-

EXPLODED VEIW

-3-

PRINTED CIRCUIT BOARD

-4-

CIRCUIT DIAGRAM 1

-5-

CIRCUIT DIAGRAM 1

-6-

PARTS LIST - 1

-7-

PARTS LIST - 2

-8-

PARTS LIST - 3

-9-