Text preview for : pachislo reset switch installation.pdf part of Pachislo Slot Machine Pachislo Pachislo Reset Switch Installation
Back to : pachislo reset switch ins | Home
http://www.pachislos.net
PACHISLO RESET SWITCH INSTALLATION
If you have lost your reset key or your reset switch does not work, installing a reset switch is the least expensive solution. Reset key and replacement locks are difficult to find and expensive. REMOVE POWER SUPPLY Unplug all cables. Each is unique, so no need to worry about getting them plugged in again when you reinstall. REMOVE SCREWS Power Supplies are usually held on with 1-3 screws. Remove all screws and slide out Power Supply. ACCESS INSIDE OF POWER SUPPLY On some Power Supplies there are side panels which need to be removed to access the inside. REMOVE RESET LOCK 1. Reset locks are held into place with a single nut. Loosen the nut with a pair of needlenose pliers. 2. If possible, unplug the cable that holds the reset lock to the Power Supply. If you cannot do this, snip the wires as close as possible to the reset lock and slide the reset lock from the front of the machine. 3. Strip rubber from the wires that lead to the reset lock. 4. Using a reset switch like the one shown in the video, try pushing it into the hole left by the old reset lock. If it does not fit, run the wires through a vent. You may need to splice extra wire to the reset wires you stripped to give you more wire to work with. 9. Thread the wire through the hole left by the old reset lock or through the vent, then thread the wire through the terminals on the reset switch. Use electrical tape to cover any exposed wire. 10. Reinstall the Power Supply.
http://www.pachislos.net