Text preview for : ts106.pdf part of Marantz PMD222 Block Diagram/Specs
Back to : Marantz PMD222.rar | Home
www.libermansound.com 510-526-5447
Marantz PMD222 Mic Preamplifier Modification
This modification reduces the input noise at the balanced XLR connector by up to 10dB. On units after serial number MZ0293xx27xxxx the improvement may be around 5.3dB, due to Marantz's upgrade of the original opamp. Some improvement can be made by simply changing the op-amp to the AD OP275, but for the full improvement the entire modification below should be performed. Note that the XLR-ECM switch now becomes XLR-Input Select. You may copy and distribute these instructions freely, as long as your retain the copyright, logo, and contact information shown on this page.It is completely our design, and has not been approved nor endorsed by Marantz. Any alteration of a unit still under warrantee may void the warrantee. Performing this modification is at your own risk, and we can not offer any technical support with this modification.
Insert SE01 here
AD OP275
from WE02 pin 2
to RE18 Rec Level 100
22/50v BP 1k
49.9k 2.2/50v AD OP275
1k 22/50v BP
24.9k 49.9k
1) Change QE01 from NJM4556 to AD OP275 (Note: Do not use NE5532A, it draws too much current) 2) Change RE06, RE09 from 4.7k to 1k 3) Change RE10 from 4.7k to 24.9k 4) Change RE07, RE08 from 10k to 49.9k 5) Change CE08, CE09 from 4.7/50v to 22/50v (preferably bipolar to protect against phantom power) 6) Change RE11 from 1k to 100 7) Change CE10 from .47/50v to 2.2/50v (if flat low end is desired) 8) Cut trace between neg side of CE13 and SE01 and connect CE13 to RE16 9) Cut trace at center contact of SE01 10) Remove jumper U018 11) Connect center contact of SE01 to side of U018 that goes to Rec Level pot RE18 12) Connect other open contact of SE01 to side of U018 that goes to WE02 pin 2 13) Affix new label to switch (XLR - Input Select) 14) Test: Voltage at QE01 pin 8 = 9.4v, THD+N = 0.14%, CMRR = >80dB @ 1k, resp same as line in ©2006 Liberman Sound Circuit ver 1, 9-13-99
MARANTZ PMD222 MIC INPUT MOD Input level S/N unweighted dB Stock Modified 47 57 67 73 57 67 74 76 S/N A-weighted dB Stock Modified 49 59 69 75 59 69 76 78
-60 -50 -40 -30
AP Output imped 150ohm PMD222 Input set to 0VU, Output level -3.2dBu THD+N: Approx 0.135% CMRR: 70dB or better