Text preview for : 5730____1beng0200.pdf part of Fluke 5730____1beng0200 Fluke 5700a 5730____1beng0200.pdf
Back to : 5730____1beng0200.pdf | Home
Certificate of Compliance
Certificate: 2118607 (LR 44340C) Master Contract: 162029
Project: 2668223 Date Issued: October 18, 2013
Issued to: Fluke Corporation
6920 Seaway Blvd
Everett, WA 98203
USA
Attention: Joe Swanzy
The products listed below are eligible to bear the CSA
Mark shown with adjacent indicators 'C' and 'US' for
Canada and US or with adjacent indicator 'US' for
US only or without either indicator for Canada only.
Paul Tanaka
Issued by: Paul Tanaka, AScT.
PRODUCTS
CLASS 8721 06 - LABORATORY EQUIPMENT - Electrical
CLASS 8721 86 - ELECTRICAL EQUIPMENT FOR LABORATORY USE - Certified to US
Standards
Calibrators, Models 5700A and 5720A: cord connected, rated 100, 110, 115, 120, 200, 220, 230, 240 V, 47-63
Hz, 300 VA max.
Calibrator, Model 5730A; cord connected rated 100-120V, 220-240V, 47-63Hz, 300VA max.
Notes:
1. The above models are cord connected, Equipment Class I, Pollution Degree 2, Installation category II;
2. Mode of operation: Continuous;
3. Environmental Conditions: Extended/as specified by manufacturer;
DQD 507 Rev. 2012-05-22 Page: 1
Certificate: 2118607 (LR 44340C) Master Contract: 162029
Project: 2668223 Date Issued: October 18, 2013
APPLICABLE REQUIREMENTS
CSA Standards:
CAN/CSA-C22.2 No. 61010-1-12 - Safety Requirements for Electrical Equipment for Measurement, Control,
and Laboratory Use, Part 1: General Requirements
CAN/CSA-C22.2 No. 61010-2-030-12 - Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use - Part 2-030: Particular requirements for testing and measuring circuits
UL Standards:
UL Std. No. 61010-1 (3rd Edition) - Safety Requirements for Electrical Equipment for Measurement, Control,
and Laboratory Use - Part 1: General Requirements
UL Std. No. 61010-2-030 (1st Edition) - Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use - Part 2-030: Particular requirements for testing and measuring circuits
Reference Standards:
EN 61010-1:2010 - Safety Requirements for Electrical Equipment for Measurement, Control, and Laboratory
Use - Part 1: General Requirements
EN 61010-2-030:2010 - Safety Requirements for Electrical Equipment for Measurement, Control, and
Laboratory Use - Part 2-030: Particular requirements for testing and measuring circuits
CONDITIONS OF ACCEPTABILITY
(1) The main supply cord set provided with the equipment must be an approved type acceptable to the
authorities in the country where the equipment is sold.
(2) The user replaceable mains (line) fuse must be an approved type acceptable to the authorities where the
equipment is sold.
(3) If at any time there is a conflict between the system safety provisions and any relevant local (national or
regional) requirements, the local requirements always take precedence.
DQD 507 Rev. 2012-05-22 Page: 2