Text preview for : 32L4333DG.html&f=Intallation_Instraction.pdf part of TOSHIBA 32L4333DG.html&f=Intallation_Instraction TOSHIBA LCD 32L4333D 32L4333DG.html&f=Intallation_Instraction.pdf
Back to : 32L4333DG.html&f=Intallat | Home
NOTE; PERSONAL AND CUSTOM PREFERENCES WILL BE LOST UPON COMPLETION
OF THIS FIRMWARE UPDATE. PLEASE MAKE NOTE OF ANY PREFERENCE SETTINGS
PRIOR TO STARTING THIS FIRMWARE UPDATE.
How to upgrade the Software
1 Remove AC power from set by unplugging the AC power cord with viewing the TV.
2 The USB reader is located on the left or right of the cabinet near the side control/jack assembly as
shown in Figure 1.
Figure 1
3 Insert the "USB Drive" into the USB slot as shown in Figure 2.
Figure 2
Copyright 2013 All Rights Reserved Page 1 of 2
4 Press the "VOL-" button on the TV side and keep it pressed.
5 Plug the TV back into AC power while keeping the "VOL-" button pressed.
6 The Software upgrading process will begin.
During the Software upgrade, the TV receiver will display "Software upgrade in progress" as shown
in Figure3.
Software upgrade in progress.
Please wait ...
DO NOT unplug your TV!
Doing so may corrupt the system
making your TV inoperable.
1%
Figure3
The progress bar will be proceed after 3 minutes
IMPORTANT:
DO NOT unplug the AC power from the TV or press any buttons on the remote controller or
the TV keypad during this process.
7 Upon completion of the Software upgrade a massage will appear as shown in Figure4.
The software upgrade is complete
Your TV system will reboot
after which you may
resume normal viewing.
100%
Figure4
8 Momentarily remove (~10 seconds) AC power from set by unplugging the AC power cord.
Remove the USB drive from the slot.
Plug the TV back into AC power. The TV should turn back on after 2 minutes.
9 Please follow the instructions on the screen to setup the TV according to your needs
(including channel setup).
Copyright 2013 All Rights Reserved Page 2 of 2