Text preview for : Disassembly & Reassembly.pdf part of Samsung Disassembly & Reassembly Samsung Monitor Monitor T200HD T220HD CH LS20TDD LS22TDD Disassembly & Reassembly.pdf
Back to : Disassembly & Reassembly. | Home
3. Disassembly and Assembly
3. Disassembly and Assembly
This section describes the disassembly and reassembly sequences for this monitor.
Warning: As this monitor has parts that are sensitive to static electricity, be careful when handling them.
3-1. Disassembly
Caution: 1. Turn the monitor off before beginning the disassembly process.
2. When disassembling the monitor, do not use any metal tools except for the provided jig.
3. Remove the signal cable and the power cord before beginning the disassembly.
Description Photo Screws
1. Place monitor face down on cushioned table.
Remove Stand, then remove 2 marked screws
from the rear cover.
Caution : If you do not tilt the stand and use too
much force to remove it, the connection
pin may break.
2. Remove the cover and the LCD panel using the
provided jig on both grooves at the bottom.
3-1
3. Disassembly and Assembly
Description Photo Screws
3. Insertaflatscrewdriverintothegrooveandthen
lift up and remove the cover.
4. After remove COVER-REAR, then disconnect
SPEAKER , FUNCTION wire.
5. Disconnect LVDS cable from panel.
3-2
3. Disassembly and Assembly
Description Photo Screws
6. After disconnecting SHIELD-LAMP of left side,
disassemble lamp wire between panel and IP
Board.
7. Remove 8 marked SCREW of left picture.
Disconnect IP board.
Reassembly procedures are in the reverse order
of disassembly procedures.
8. Remove the LCD panel.
3-3
3. Disassembly and Assembly
Description Photo Screws
9. Remove the IR module by tilting the left snap to
the right.
10. Remove the LED module by sliding the snap
designatedintherightfigurebackwards.
11. Remove the two (2) screws and then remove the
holders from the four (4) snaps designated in the
rightfigureusingtheprovidedjig.
3-4
3. Disassembly and Assembly
Description Photo Screws
12. Remove the two (2) connectors.
Caution : Servicing is not supported for the PCB.
Assembly
13. The assembly is in the reverse order of the
disassembly.
14. Connect the disassembled snap and the LED
module again.
15.Fixtheconnectingwirewithfilamenttape
Caution : If the wire is damaged when closing the
cover, an operating error may occur.
Therefore, make sure to close the
coverafterfixingitwithfilamenttape.
filamenttape
The assembly is in the reverse order of disassembly.
3-5
3. Disassembly and Assembly
Memo
3-6