Text preview for : Installation_Instruction.pdf part of TOSHIBA Installation Instruction TOSHIBA LCD 32HL933G Installation_Instruction.pdf
Back to : Installation_Instruction. | Home
How to upgrade the Software
1 Connect the AC power and turn "ON" the TV receiver.
2 The USB reader is located on the left of the cabinet near the side control/jack assembly
as shown in Figure1.
Figure1
3 Insert the "USB Drive" into the USB slot as shown in Figure2.
Figure2
Copyright 2011 All Rights Reserved Page 1 of 3
4 Press the "MENU" button on the remote controller.
Use the Arrow buttons on the remote controller to select the "SET UP" menu.
Press the "OK" button on the remote controller to enter the SET UP Menu as shown in Figure.3
Figure3
5 SET UP menu will be displayed as shown in Figure.4
Figure4
6 In the "SET UP" menu, scroll down to the "Software Upgrade" as shown in Figure5.
Figure5
Note; "USB Upgrade" may not be visible until you select it through "SET UP" menu.
Copyright 2011 All Rights Reserved Page 2 of 3
7 Press "OK" bottom of the remote controller to begin the upgrade.
8 The software upgrading process will begin. During the software upgrade, the TV receiver will display
"USB Upgrade" as shown in Figure6.
During this time, do not remove power to the television or press any remote keys or buttons
on the television until the upgrade is complete!
Figure6
9 Upon completion of the software upgrade, The TV will reboot automatically.
10 Remove the "USB Drive" from the slot.
Copyright 2011 All Rights Reserved Page 3 of 3