Text preview for : 20050921103757437_11_assembly_168.pdf part of Samsung 20050921103757437 11 assembly 168 Samsung LCD Proj LE32T51 20050921103757437_11_assembly_168.pdf
Back to : 20050921103757437_11_asse | Home
11 Disassembly and Reassembly
11 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the
LE23T51B/LE27T51B/LE32T51B TFT-LCD monitors.
WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling
these components.
(ONLY LE32T51B) Check the connector of POWER BOARD which are CNM 802, 803.
IF Panel MARK is A(AUO), The wire which is from PANEL INVERTER Must be
connected into CNM 803.
IF Panel MARK is S(Sec), The wire which is from PANEL INVERTER Must be
connected into CNM 802.
11-1 Disassembly
Cautions: 1. Disconnect the monitor from the power source before disassembly.
1. Place LCD-TV face down on cushioned table.
Remove 14 screws from the rear-cover and Remove stand.
2. Remove 2 screws from the cover-jack.
Lift up the rear-cover.
11-1
11 Disassembly and Reassembly
23"(AM-LCD Panel)
27"(CMO Panel)
32"(AM-LCD Panel)
32" (AUO Panel)
3. Disconnect cables and remove 6 screws from the power board.
4. Remove 4 screws from the main board.
Lift up the power board.
5. Lift up the main board and remove 10 secews from the BRKT.
11-2
11 Disassembly and Reassembly
6. Remove 4 screws and Lift up the Lcd panel.
7. Remove 4 screws
11-2 Reassembly
Reassembly procedures are in the reverse order of disassembly procedures.
11-3
11 Disassembly and Reassembly
Memo
11-4