Text preview for : svp310_320_350service.pdf part of SELECO svp310 320 350service SELECO TV svp310_320_350service.pdf
Back to : svp310_320_350service.pdf | Home
SERVICE ADJUSTMENTS SVP310-320-
350
SERVICE ADJUSTMENTS
93
SERVICE ADJUSTMENTS SVP310-320-
350
94
SERVICE ADJUSTMENTS SVP310-320-
350
SERVICE ADJUSTMENTS
These adjustments must be performed when particular components, as CRT, yoke, etc., have been replaced.
MAGNET ADJUSTMENT
Signal: video composite 15KHz connected to VIDEO 1.
UPC ON (projector working at 32 KHz).
non-pole
50 mm
CENTERING MAGNETS ADJUSTMENT
? Adjust CONV/CENT H V to 50
? UPC ON
? Rotating the centering magnets align the raster in the center of the tube screen.
2/4 POLE ADJUSTMENT
1. Select the HATCH COARSE test pattern, using the TEST button on the full function remote control.
2. Adjust the focus potentiometer of the corresponding CRT completely in anti-clockwise.
3. Adjust the 2 pole magnet till the flare is equal on both sides of the vertical and horizontal lines (see following figure).
95
SERVICE ADJUSTMENTS SVP310-320-
350
not correct correct
4. Select the DOTS test pattern, using the TEST button on the full function remote control.
5. Adjust the focus potentiometer of the replaced CRT slightly clockwise.
6. Adjust the 4-pole magnet till the dots have the best circular shape in the center of the screen (see following figure).
not correct correct
Note. Repeat the 2-pole and 4-pole magnets alignments if necessary, because they influence each other.
7. Select the HATCH COARSE test pattern, using the TEST button on the full function remote control.
8. Adjust the focus till the flare disappear from the lines.
How to adjust the 2/4 pole
X
Y
X: adjusts the power of magnetic force
Y: adjusts the direction of the magnetic force
96
SERVICE ADJUSTMENTS SVP310-320-
350
SERVICE MODE
Conditions:
Signal generator: - 15 KHz, grey scale.
Plug a jumper into JP1 position of the JP101 connector placed on the PC157 microboard.
Switch-on the projector by the mains switch, on the screen will appear flashing:
FACTORY SET
Into this mode are possible to carry out the factory adjustments, as the following:
G2 AND WHITE BALANCE ADJUSTMENT.
Press OPT button, will appear:
OPTIONS MENU
OSD
INSTALLATION TYPE
POWER ON
VCR STABILITY
MEMORY MANAGER
WORKING TIME
SERVICE MENU
Select SERVICE MENU, press ENTER, will be displayed:
SERVICE MENU
CONFIGURATION
G2 ADJUST
IIC ON
INPUTS
PEAK LIMIT
CONV 15K/50Hz
97
SERVICE ADJUSTMENTS SVP310-320-
350
Select G2 ADJUST, press ENTER, will be displayed:
G2 ADJUST
BLACK 49 49 49
WHITE 49 49 49
In this condition brightness and contras will be automatically fixed at 50.
Connect an oscilloscope probe 100:1 to R481 (cathode) of the PC152 CRT board of the red tube.
Adjust the red G2 potentiometer to have 140 V of the cut-off level.
Repeat the same operations for the green and blue tubes.
Press VID.S, will appear:
VIDEO SETUP
Y/C DELAY
WHITE BALANCE
COMB FILTER
GAMMA ADJ
ADAPTIVE BLACK
BLUE STRETCH
Select WHITE BALANCE, will appear:
WHITE BALANCE
3200 K ADJ
? 6500 K ADJ
9300 K ADJ
USER ADJ
FACTORY SET
This menu permits to change the three color temperature sets, preset in Factory, at 3200