Text preview for : disassembly__reassembly.pdf part of Samsung disassembly reassembly Samsung LCD TV 933HD CHASSIS LS19CFE disassembly__reassembly.pdf
Back to : disassembly__reassembly.p | Home
3. Disassembly and Assembly
3. Disassembly and Assembly
This section describes the disassembly and reassembly sequences for this monitor.
Warning: As this monitor has parts that are sensitive to static electricity, be careful when handling them.
3-1. Disassembly
Caution: 1. Turn the monitor off before beginning the disassembly process.
2. When disassembling the monitor, do not use any metal tools except for the provided jig.
3. Remove the signal cable and the power cord before beginning the disassembly.
Description Photo Screws
1. Place monitor face down on cushioned table.
Remove Stand.
Caution : If you do not tilt the stand and use
too much force to remove it, the
connection pin may break.
2. Remove the cover and the LCD panel using
the provided jig one side grooves at the
bottom.
Caution : Remove the cover and the LCD
panel using the provided jig on
both grooves at the bottom.
If you disassemble the product with
only one side opened, it may be
damaged.
3-1
3. Disassembly and Assembly
Description Photo Screws
3. Insertaflatscrewdriverintothegrooveand
then lift up and remove the cover.
4. After remove COVER-REAR, then
disconnect SPEAKER , FUNCTION wire.
5. Disconnect LVDS cable from panel.
3-2
3. Disassembly and Assembly
Description Photo Screws
6. After disconnecting SHIELD-LAMP of left
side, disassemble lamp wire between panel
and IP Board.
7. Remove 8 marked SCREW of left picture.
Disconnect IP board.
Reassembly procedures are in the reverse
order of disassembly procedures.
8. Remove the LCD panel.
3-3
3. Disassembly and Assembly
Description Photo Screws
Assembly
9. The assembly is in the reverse order of the
disassembly.
10. Connect the disassembled snap and the
LED module again.
The assembly is in the reverse order of disassembly.
3-4