Text preview for : 31-21456 GE RANGE.pdf part of General Electric 31-21456 GE RANGE General Electric 31-21456 GE RANGE.pdf
Back to : 31-21456 GE RANGE.pdf | Home
IMPORTANT SAFETY NOTICE NOTE: The orifices have spring loaded retaining BURNER OUTPUT RATINGS; BTU/HR LOW FLAME (SIMMER) ADJUSTMENT
183D8077G179
T H I S I N F O R M AT I O N I S I N T E N T E D F O R U S E B Y P E R S O N S
POSSESSING ADEQUATE BACKGROUNDS OF ELECTRICAL,
rings around the hex head to hold the orifice in
the nutdriver during installation and removal. Natural Gas, 5" W.C.P
The top burner valves have low flame/simmer
adjustment screws in the center of the control SCHEMATIC DIAGRAM
ELECTRONIC AND MECHANICAL EXPERIENCE. ANY ATTEMPT TO A slight amount of force is required to push the BURNER BTU RATE ORIFICE SIZE valve shafts. A flashlight may be required to
R E PA I R A M A J O R A P P L I A N C E M AY R E S U LT I N P E R S O N A L
INJURY AND PROPERTY DAMAGE. THE MANUFACTURER OR
nutdriver down over the ring.
RF 17,000 0.0783" (1.98mm)
locate the screw. A thin, flat bladed screwdriver
REPLACING ORIFICE HOLDER AND TUBING WARNING
d) Install the LP orifice spuds into their correct (approx. 3/32 across) is needed to access the The Orifice Holder and Supply Tubing are one
SELLER CANNOT BE RESPONSIBLE FOR THE INTERPRETATION LF 12,000 0.064" (1.62mm)
screw. assembly. To replace the assembly: POWER MUST BE DISCONNECTED
OF THIS INFORMATION, NOR CAN IT ASSUME ANY LIABILITY IN positions as described as follows.
CONNECTION WITH ITS USE. LR 9,500 0.0555" (1.41mm) Follow the instructions under "Raise or Remove BEFORE SERVICING THIS APPLIANCE
RR 5,000 0.0409" (1.04mm) To Adjust The Low Flame Setting-At least 2 cooktop" (column 4).
COM NO O
DISCONNECT POWER BEFORE SERVICING LP- Orange /
CENTER 10,000 0.058" (1.473mm) other surface burners must be lit. Then, lite the Remove the 3/4" nut securing the orifice holder Y
IMPORTANT-RECONNECT ALL Green
burner being adjusted and turn knob to "LOW". being replaced to the bracket. Use a 3/4" open LATCH
SWITCH
COM NO S
GROUNDING DEVICES. BAKE 16,000 #49 (.073") ended or adjustable wrench to loosen the nut.
Remove knob and insert the screwdriver into Y
NOTES:
BROIL 13,500 #51 (.067") valve shaft. Turn the adjustment screw until the Loosen the 1/2" nut securing the tubing to the M1
W
ALL PARTS OF THIS APPLIANCE CAPABLE OF CONDUCTING OVEN 1. WARNING: POWER MUST BE DISCONNECTED BEFORE
ELECTRICAL CURRENT ARE GROUNDED. IF GROUNDING WIRES, LP- Blue / LP- Blue / flame reaches the desired size. valve. SENSOR M2
S
SERVICING THE APPLIANCE.
Brown Blue 162 Denotes 1.62mm Orifice size opening
POWER SUPPLY
SCREWS, STRAPS, NUTS OR WASHERS USED TO COMPLETE A TOROID
AT 75