TEK P3420 Instruction.pdf part of Tektronix TEK P3420 Instruction TEK P3420 Instruction.pdf, Tektronix TEK P3420 Instruction.pdf text manual preview

Text preview for : TEK P3420 Instruction.pdf part of Tektronix TEK P3420 Instruction Tektronix TEK P3420 Instruction.pdf

Back to : TEK P3420 Instruction.pdf | Home

P3410 and P3420 Instructions

Instructions P3410 Front Panel

This package contains either a P3410 TTL pod or a P3420 variable
pod. Twelve cables are supplied with each pod (012-1502-XX for
the P3410 and 012-1504-XX for the P3420). Both pods are designed P3420 Front Panel
to be used with the Tektronix DG2020 or DG2020A Data Generator.
Refer to Figure 1 to determine which pod you are using.
Information for installation, operations, specifications, and
accessories can be found in the DG2020 or DG2020A User Manual.
The following instruction describes about the cable connection only
between the Pod and the DG2020A. However, if your data generator
is the DG2020, you can also read this instruction as replacing Figure 1: P3410 and P3420 front panels
DG2020A with DG2020.
Pod Rear Panel

Precaution for Connecting Cable Tab Slot DG2020A Rear Panel
Yellow Index
Mark
CAUTION. Make sure that you have correctly inserted the cable
plug in the DG2020A and the pod before turning on power. The
yellow wire end of the connector must be aligned with the Yellow Index
triangular yellow index mark on the DG2020A or pod. Mark
Incorrectly connected cables will damage the DG2020A and the
pod.
To connect a cable between the DG2020A and a
pod, align the yellow wire end of the cable connector
Note that the connectors on the DG2020A rear panel are installed with the triangular yellow index mark on the
with the tab slot down, and the connector on the pod rear panel is DG2020A or pod connector. Doing this also correctly
installed with the tab slot up (see Figure 2). aligns the connector alignment tab. Then carefully
but firmly insert the cable connector into the
To connect a cable between the DG2020A and a pod, align the yellow DG2020A or pod connector. Tab
wire end of the cable connector with the triangular yellow index
mark on the DG2020A or pod connector. Doing this also correctly
aligns the connector alignment tab. See Figure 2. Then carefully but Yellow Wire Tab Slots
firmly insert the cable connector into the DG2020A or pod connector.
Cable
For further information for connection, refer to the DG2020A User
Manual titled DG2020A Data Generator With P3410 & P3420 Pods.
Figure 2: Yellow index mark and yellow wire for cable connection
Instructions

P3410 TTL P3420

12 (
1 ) P3410 TTL Pod
P3420 Variable Pod
H P3410 : 012-1502-XX
H P3420 : 012-1504-XX
DG2020
DG2020A
DG2020A
DG2020

DG2020A

DG2020A DG2020A
Copyright