40WH08_SIGNAL_CCT.pdf part of TOSHIBA 40WH08 SIGNAL CCT 40WH08_SIGNAL_CCT.pdf, TOSHIBA LCD Proj 40WH08 40WHO8G chasis COOP 40WH08_SIGNAL

Text preview for : 40WH08_SIGNAL_CCT.pdf part of TOSHIBA 40WH08 SIGNAL CCT TOSHIBA LCD Proj 40WH08 40WHO8G chasis COOP 40WH08_SIGNAL_CCT.pdf

Back to : 40WH08_SIGNAL_CCT.pdf | Home

SCHEMATIC DIAGRAM MODEL : 40WH08B / 40WH08G

WARNING: BEFORE SERVICING THIS CHASSIS, READ THE "X-RAY RADIATION PRECAUTION", "SAFETY NOTE:
PRECAUTION" AND "PRODUCT SAFETY NOTICE" ON THE MANUAL FOR THIS MODEL. 1. RESISTOR Resistance is shown in ohm [K = 1.000, M = 1.000.000]. All resistors are 1/6W and 5% 4. Voltages read with DIGITAL MULTI-METER from point indicated to chassing ground, using a color bar signal with all
tolerance carbon resistor, unless otherwise noted as the following marks. controls at normal, line voltage 220 volts.
CAUTION: The international hazard symbols "*" in the schematic diagram and the parts list designate components 1/2R = Metal or Metal oxide of 1/2 watt 1/2S = Carbon compsistion of 1/2 watt 5. Waveforms are taken receiving color bar signal with enough sensitivity.
which have special characteristics important for safety and should be replaced only with types identical to those in the 1RF = Fuse resistor of 1 watt 10W = Cement of 10 watt 6. Voltage reading shown are nominal values and may vary