Text preview for : 740NW[2].pdf part of Samsung 740NW[2] Samsung Monitor Monitor 740NW - 940NW 740NW 740NW[2].pdf
Back to : 740NW[2].pdf | Home
11 Disassembly and Reassembly
11 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the
LS17HAN TFT-LCD monitors.
WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling
these components.
11-1 Disassembly
Cautions: 1. Disassemble stand on a flat desk.
2. Disconnect the monitor from the power source before disassembly.
Description Picture Description
1. Place the monitor on a table so that its back is
towards you, as shown in the left figure.
Remove the three (3) screws at the bottom of
the back cover that hold it in place.
Turn the monitor so that its front part is towards
you. Pry the front and back covers apart using
your fingers.
2. Remove the front cover.
11-1
11 Disassembly and Reassembly
Description Picture Description
3. Turn the monitor so that its front part is looking
downwards. Then remove the back cover, as
shown in the figure on the left.
4. Remove the lamp protection shield on the left of
the shield (back cover). Then remove the two
(2) lamp wires and the function connector.
(Be careful Shield.)
Lamp Protection Shield
5. Lift up the shield. Check and remove the
connections between the FFC cable and the
panel. Then remove the shield from the panel.
11-2
11 Disassembly and Reassembly
Description Picture Description
6. Remove 2 screws.
7. Turn the shield so that its inside looks upwards.
Remove all the screws on the main board and
the IP board (total 4 screws). Then remove the
protection shield at the bottom of the IP board.
8. Main board and IP-Board.
IP - BOARD MAIN BOARD
11-3
11 Disassembly and Reassembly
11-2 Reassembly
Reassembly procedures are in the reverse order of disassembly procedures.
11-4