Text preview for : 20050617095258859_DJ750_1Disa_TM.pdf part of Samsung 20050617095258859 DJ750 1Disa TM Samsung Audio MAX-DJ750 20050617095258859_DJ750_1Disa_TM.pdf
Back to : 20050617095258859_DJ750_1 | Home
Diassembly and Reassembly
1. Disassembly and Reassembly
1-1 Cabinet-Top
* If power is connected ;
1. Turn power on and open the CD - TRAY ,push the Door-CD in the direction of arrow A to remove.
2. Close the CD - TRAY and turn power off, and remove the power plug(cord) from main power
3. Remove 9 screws of ! holding the Cabinet-Top in the direction of arrow B.
Lift the back of the Cabinet-Top and shade it to the rear to remove.
* If power is not connected ;
1. Remove 9 screws of ! holding the Cabinet-Top in the direction of arrow B.
Lift the back of the Cabinet-Top and shade it to the rear to remove.
2. Remove the Cabinet-Top and Turn the Gear the clockwise using the hand as shown in figure 3-1-1.
Open the Door-CD and pull the Tray in the direction of arrow @ as shown in figure 3-1-1.
1
TRAY
2
Figure 3-1-1
Figure 3-1
Samsung Electronics 1-1
Diassembly and Reassembly
1-2 CD-Mecha, Door-CD
1. Remove 4 screws of # .
2. Lift the back of the CD-Mecha to remove.
Figure 3-2
1-2 Samsung Electronics
Diassembly and Reassembly
1-3 Cabinet-Rear
1. Remove 21 screws of $.
2. Lift the Cabinet-Rear in the direction of arrow D and slide it to the rear
by releasing the hook of Cabinet-Bottom.
Figure 3-3
1-4 Cabinet-Front , Cabinet-Bottom and main PCB
1. Remove3 screws of ^,Cabint-Front in the direction of arrow F and slide to the Cabinet-Bottom.
2. Remove 1 screws of % and slide the Main PCB to te rear to remove.
3. Remove 1 screws of & and slide the AMP PCB and DVD PCD to remove .
Figure 3-4
Samsung Electronics 1-3
Diassembly and Reassembly Diassembly and Reassembly
1-5 Pick-up disassembly and reassembly
1-5-1 Disassembly 1-5-2 Assembly
1) Remove the power cable. 1) Replace the Pick-up.
2) Switch LD SW1 on deck PCB to `OFF' before 2) Assemble the deck PCB.
removing the FPC 3) Reassemble the deck.
( Inserted into Main PCB CN6. See Fig. 3-5)
3) Disassemble the deck.
4) Disassemble the deck PCB.
Note : If the assembly and disassembly are not done in correct sequence, the Pick-up may be damaged.
Figure 3-5
1-4 Samsung Electronics