Text preview for : 4.Disassembly_and_Reassembly.pdf part of Samsung 4.Disassembly and Reassembly Samsung Microwave ME21F707MJT_AA Service Manual 4.Disassembly_and_Reassembly.pdf



Back to : 4.Disassembly_and_Reassem | Home

3. Disassembly and Reassembly

MAGNETRON, MOTOR ASSEMBLY, VENT BLOWER AND HIGH VOLTAGE TRANSFORMER
Oven must be removed from wall.
REMOVING OVEN FROM WALL (2 PEOPLE REQUIRED)



Disconnect the power cord from the outlet.

The oven is hooked on the metal tabs of the wall
mounting plate that is secured to the wall. It is not
necessary to remove this mounting plate to service this
unit.
This unit is attached to the cabinet above by two self
aligning screws. Support the unit while removing these
screws allowing it to hinge downward to disengage the
unit from the mounting plate.


House Duct




Be aware there may also be a connection to the range
vent ductwork that is attached to the top or back of the
unit through an exhaust adapter/damper.




Remove the oven from the wall




9
3. Disassembly and Reassembly

3-1 Replacement of High Voltage Transformer

Parts Explaination Photo Explaination




1. Disconnect oven power.

2. Remove Grille.
Grille
1) Remove 2 screws
2) Slide the Grille to the left,
then pull it straght out.




3. Remove Panel Outer by
Panel Outer pulling it to the rear of the set.




10
3. Disassembly and Reassembly

3-1 Replacement of High Voltage Transformer

Parts Explaination Photo Explaination




4. Discharge the High voltage capacitor.




High voltage
capacitor



5. Disconnect all the leads.




6. Remove
Base Bottom Base
bottom.




HV Trans 7. Take out the HV Trans.




11
3. Disassembly and Reassembly

3-2 Replacement of Magnetron

Parts Explaination Photo Explaination




Remove the magnetron including the shield
case, permanent magnet, choke coils and
capacitors (all of which are contained in one
assembly).
1. Disconnect all lead wires from the
magnetron.


Magnetron



2. Remove nuts (2) securing the magnetron
to the wave guide.
3. Take out the magnetron very carefully.




NOTE1: When removing the magnetron, make sure that it antenna does not hit any adjacent parts, or it may be
damaged.
NOTE2: When replacing the magnetron, be sure to remount the magnetron gasket in the correct position and make
sure the gasket is in good condition.
NOTE3: Reconnect the lead wire to thermal cutout mounted on the magnetron, before replace the magnetron.



PRECAUTION
During replacement, be certain R.F. anode gasket is in place around anode stub.
PERFORM MICROWAVE LEAKAGE TEST




12
3. Disassembly and Reassembly

3-3 Replacement of Fan Motor

Parts Explaination Photo Explaination




1. Remove Grille and Panel Outer.
2. Disconnect all lead wires from Fan Motor
and High Voltage Transformer.




3. Put out Assy Fan Motor.




Fan Motor


4. Remove Fan Blade.
5. Remove screws (2) securing Fan Motor.
6. Replace Fan Motor to new one.




7. After replacing Fan Motor and
reconnecting lead wires, make sure that
the connectors are connected securely on
the terminal of Fan Motor by pulling the
wires lightly.




13
3. Disassembly and Reassembly

3-4 Replacement of Door Assembly
Parts Disassembly Photo Explaination




1. Disconnect the lead wire.
Removal of 2. Remove Door pin.
Door Pin
Door Assembly 3. Open the Assembly Door by degree 90