Text preview for : Disassembly & Reassembly.pdf part of Samsung Disassembly & Reassembly Samsung Monitor Monitor 943NXW LS19MYNKBBEDC Disassembly & Reassembly.pdf
Back to : Disassembly & Reassembly. | Home
3. Disassembly and Assembly
3. Disassembly and Assembly
This section describes the disassembly and reassembly sequences for this monitor.
Warning: As this monitor has parts that are sensitive to static electricity, be careful when handling them.
3-1. SIMPLE STAND Disassembly
Caution: 1. Turn the monitor off before beginning the disassembly process.
2. Disassemble the monitor carefully as directed in the following procedures.
3. When disassembling the monitor, do not use any metal tools except for the provided jig.
Description Photo Screws
1. Place a soft cloth on the table and place
the monitor onto it with the front part facing
downwards. Hold the monitor set with one hand
and hold and pull the stand body backwards with
the other hand to remove the stand body from the
monitor set.
Caution : : If you do not tilt the stand and use too
much force to remove it, the connection
pin may break.
2. Turn the monitor over and insert your hands
into the top of the monitor at the center and
separate the front cover in the direction of the
arrow as shown in the figure.
Separate the sides of the front cover up to the
directed line as shown in the figure.
3. Turn the monitor over again to remove the back
cover.
3-1
3. Disassembly and Assembly
Description Photo Screws
4. Remove the SHIELD-LAMP using the provided JIG.
Caution: The SHIELD-LAMP is sharp.
5. Remove the LVDS, LAMP wire, FUNCTION
cable, and SPEAKER cable, and then remove LVDS
the SHIELD-COVER.
LAMP
WIRE
FUNCTION
6. Remove the LCD panel..
7. Remove the four (4) screws shown in the figure.
8. Remove the four (4) screws shown in the figure
and remove the Bracket support.
3-2
3. Disassembly and Assembly
Description Photo Screws
9. Remove the main PCB and IP boards from the
SHIELD-cover.
The assembly is in the reverse order of disassembly.
3-3
3. Disassembly and Assembly
3-2. HAS STAND Disassembly
Description Photo Screws
1. If the Stopper PIN at the back of the stand is
not removed, place a soft cloth on the table and
place the monitor on it, and then hold the monitor
set and remove the Stopper PIN at the back of
the stand.
2. Turn the monitor over. Remove the two (2) screws
that hold the stand in place and then remove the
stand.
Caution: When removing the screws, hold
the stand body with one hand
so that the stand does not fall.
3. The following steps are the same as steps 2 to 9 for disassembling the SIMPLE stand.
The assembly is in the reverse order of disassembly.
3-4