Text preview for : 04.Disassembly & Reassembly.pdf part of Samsung 04.Disassembly & Reassembly Samsung Monitor Monitor GY16CS 04.Disassembly & Reassembly.pdf
Back to : 04.Disassembly & Reassemb | Home
3 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the
GY15CS* TFT-LCD monitors.
WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling
these components.
3-1 Disassembly
Cautions:1. Disconnect the monitor from the power source before disassembly.
2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.
3. R/Cover opening jig : BH81-00001A
1. Locate the monitor on the cushion table face
down.
2. Loosen the snaps on stand door through the
slot on rear cover. Remove 4 screws.
3. Remove 2 cable screws.
4. Remove 2 screws on the rear cover.
5. Open the rear cover by using an opening jig.
GY15CS* 3-1
3 Disassembly and Reassembly
6. Remove 2 screws of PCB shield.
7. Disconnect the panel(inverter) cable from
IP-board.
8. Remove 7 screws of IP-board.
9. Separate front assy and panel assy.
10 Remove 4 screws on LCD-panel.
3-2 GY15CS*