Text preview for : Casio_EV-1000.pdf part of Casio Casio EV-1000 Casio Pocket TV EV-1000 Casio_EV-1000.pdf
Back to : Casio_EV-1000.pdf | Home
10.4" TFT-LCD TV
SERVICE MANUAL
CHASSIS :
MODEL : EV-1000
CONTENTS
Contents ................................................................................................................ 2
Safety Precautions ............................................................................................3
Specifications ......... ........... ..... ........... ..... ........... ..... ........... ..... ........... ..... ........... . 4
C o n t r o l D e s c r i p t i o n s . . . . . . . . . . . . . . .. . . . . . . . . . . . . .. . . . . . . . . . . . .. . . . . . . . . . . . . .. . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . 5 - 6
A d j u s t me n t . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
Troubleshooting............... ...... . ......... ...... . ......... ...... . ......... ...... . ......... ...... . ......... ...8-9
Exploded View .................................................................................................. 10-11
R e p la c e m e n t Pa r t s L is t . . . .. . . . . .. . . .. . . . .. . . . . . .. . . .. . . . .. . . . . . .. . . .. . . . .. . . . . . .. . . .. . . . .. . . .. . .. . . .. 1 2 - 1 6
Schematic Diagram ........................................................................................ 17
PCB Printings ................................................................................................... 18-21
SAFETY PRECAUTIONS
Important Safety Notice
Many electrical and mechanical parts in this chassis have special safety-related characteristics. These
parts are identified by in the Schematic Diagram and Replacement Parts List.
It is essential that these special safety parts should be replaced with the same components as
recommended in this manual to prevent Shock, Fire, or other Hazards.
Do not modify the original design without permission of manufacturer.
Leakage Current Hot Check (See below Figure)
Plug the AC cord directly into the AC outlet.
Do not use a line Isolation Transformer during this check.
Connect 1.5K/10watt resistor in parallel with a 0.15uF capacitor between a known good earth ground (Water
Pipe, Conduit, etc.) and the exposed metallic parts.
Measure the AC voltage across the resistor using AC voltmeter with 1000 ohms/volt or more sensitivity.
Reverse plug of the AC cord into the AC outlet and repeat AC voltage measurements for each exposed
metallic part. Any voltage measured must not exceed 0.75 volt RMS, which is, corresponds to 0.5mA.
In case any measurement is out of the limits specified, there is possibility of shock hazard and the set must
be checked and repaired before it is returned to the customer.
Leakage Current Hot Check circuit
SPECIFICATIONS
Note : Specifications and others are subject to change without notice for improvement.
1. Power requirement: 8. OSD (On Screen Display) :