Text preview for : 24661A(DASCARDCEInfo).pdf part of Keithley 24661A(DASCARDCEInfo) Keithley DAS 24661A(DASCARDCEInfo).pdf



Back to : 24661A(DASCARDCEInfo).pdf | Home

CE Information for the
DASCard-PIO12

Note: Products that contain the CE mark are certified to meet European
EMC directive 89/336 EEC. If this directive is not of importance to your
application, please disregard the information in this document.


Keithley MetraByte certifies that this product has been tested and found
to be in compliance with the EMC directive and relevant harmonized
standards.

This document describes the limitation of certification, the declaration of
conformity, and the cabling instructions required for the CE
configuration.


Limitation of Certification

This certification applies only to the operation of the product (with
specified cables and accessories) in the stated configuration and under the
stated operational and environmental specifications. Any modification,
misuse, or improper or inadequate maintenance of the product by the user
voids this certification.

Any deviation from the specific configuration may cause emissions or
susceptibility not within the allowed limits required by the stated
directive. It is the user's responsibility to demonstrate and maintain
compliance with the directive and standards.

Please read the next section, "Declaration of Conformity," for the specific
testing configuration for this product. Consult the Keithley Instruments
GMBH office (European importer) or Technical Support in Taunton, MA,
USA, for further information regarding the exact configuration details and
results.


Part Number: 24661; Revision A 1
Declaration of Conformity

Application of Council Directive(s) 89/336/EEC
Standard(s) to which Conformity is EN50081-1, EN50082-1
Declared
Manufacturer's Name Keithley MetraByte
Importer's Name Keithley Instruments GMBH
Importer's Address Landsberger Str.65 D-82110 Germering, Munich
Type of Equipment Data Acquisition Plug-in Boards
Model Numbers DASCard-PIO12, STA-U, DASCard-PIO12 cable, and
snap-on ferrite clip
Year of Manufacture 1995


I, the undersigned, hereby declare that the equipment specified above conforms
to the above Directive(s) and Standard(s).
Place: Taunton, MA USA
___________________________________
(Signature)

Date: 01 April 1996 Mark Urban
(Name)

Quality Assurance Manager
(Position)




2 April 1996
Cabling Instructions for the CE Configuration

Use the DASCard-PIO12 cable to connect the DASCard-PIO12 card to
the STA-U, as shown in Figure 1.



DASCard-PIO12 cable

STA-U




DASCard-PIO12



Figure 1. Connecting the DASCard-PIO12 Card to an STA-U

To complete the CE configuration, perform the following steps:
1. Position the supplied ferrite clip about 1/2-inch from the end of the
cable connector attached to the DASCard-PIO12 card, as shown in
Figure 2.
2. Snap the ferrite clip to the DASCard-PIO12 cable.



DASCard-PIO12
cable STA-U



DASCard-PIO12


Ferrite Clip;
Snap on 1/2-inch from the
cable connector to the
DASCard-PIO12 card


Figure 2. Snapping on the Ferrite Clip




Part Number: 24661; Revision A 3