Text preview for : IC910H_serv.pdf part of Icom IC910H serv Icom IC910H_serv.pdf
Back to : IC910H_serv.pdf | Home
SERVICE
MANUAL
VHF/UHF ALL MODE TRANSCEIVER
i910H
INTRODUCTION DANGER
This service manual describes the latest service information NEVER connect the transceiver to an AC outlet or to a DC
for the IC-910H VHF/UHF ALL MODE TRANSCEIVER at the power supply that uses more than 16 V. This will ruin the
time of publication. transceiver.
DO NOT expose the transceiver to rain, snow or any liquids.
VERSION No. VERSION SYMBOL
DO NOT reverse the polarities of the power supply when
#02 Europe EUR connecting the transceiver.
#04 Australia AUS
DO NOT apply an RF signal of more than 20 dBm (100 mW)
#06 U.S.A. USA-1 to the antenna connector. This could damage the transceiv-
#07 Korea KOR er's front end.
To upgrade quality, any electrical or mechanical parts and
internal circuits are subject to change without notice or
obligation.
ORDERING PARTS REPAIR NOTES
Be sure to include the following four points when ordering 1. Make sure a problem is internal before disassembling
replacement parts: the transceiver.
2. DO NOT open the transceiver until the transceiver is
1. 10-digit order numbers disconnected from its power source.
2. Component part number and name 3. DO NOT force any of the variable components. Turn
3. Equipment model name and unit name them slowly and smoothly.
4. Quantity required 4. DO NOT short any circuits or electronic parts. An insu-
lated tuning tool MUST be used for all adjustments.
5. DO NOT keep power ON for a long time when the trans-
ceiver is defective.
1110003140 IC LA1150N IC-910H MAIN UNIT 5 pieces 6. DO NOT transmit power into a signal generator or a
8810005770 Screw BiH M3