Text preview for : GC28-6692-2_OS_Operator_Procedures_Release_21_May72.pdf part of IBM GC28-6692-2 OS Operator Procedures Release 21 May72 IBM 360 os R21.0_Mar72 GC28-6692-2_OS_Operator_Procedures_Release_21_May72.pdf
Back to : GC28-6692-2_OS_Operator_P | Home
File No. S360-20
Order No. GC28-6692-2 OS
Systems Reference Library
IBM System/3S0 Operating System:
Operator's Procedures
This book is for the operator of an IBM System/360
Operating system and is to be used with the Operator's
Reference, GC28-6691. This book contains procedures for
running the three major system types: Primary Control
Program (PCP); Multiprogramming with a Fixed number of
tasks (MFT); and Multiprogramming with a Variable number
of Tasks (MVT). It also contains operator procedures that
apply to all three systems. Operator control panel procedures
on tear out sheets are provided for the Operator's console.
Preface
To run the operating system, you must have the required
books listed below, as well as this procedures book. In
addition, you are encouraged to read the recommended
books.
Required Books
IBM System/360 Operating System:
Operator's Reference, GC28-6691
Messages and Codes, GC28-6631
If you have a display tube console you will need:
Operator's Guide for Display Consoles, GC27-6949
Recommended Books
IBM System/360 Operating System:
Utilities, GC28-6586
Job Control Language Reference, GC28-6704
Third Edition (May, 1972)
This is a reprint of GC28-6692-1 incorporating changes released in the following
Technical Newsletters:
GN28-2474 (dated June 1,1971)
GN28-2508 (dated January 15, 1972)
Requests for copies of IBM publications should be made to your IBM representative
or to the IBM branch office serving your locality.
A form for readers' comments is provided at the back of this publication. If the
form has been removed, comments may be addressed to IBM Corporation,
Publications Development, Department D58, Building 706-2, PO Box 390,
Poughkeepsie, N.Y. 12602. Comments become the property of IBM.