Text preview for : TRG1_500RevA_DocSpec.pdf part of Keithley TRG1 500RevA DocSpec Keithley 500 TRG1_500RevA_DocSpec.pdf
Back to : TRG1_500RevA_DocSpec.pdf | Home
SOO-TRGl SPECIFICATIONS:
Ch""d9: 1, differential Input.
input scmrcc: External trigger input, Global Ampllfler output of AMMlAor AMht2, or Software Strobe.
Input Ranges: 0 to +lV, 0 to -IV, 0 to +1ov or 0 to -lov.
R.%OlUtlOn: E-bits.
Level Accuracy +z% + 1Ls.B.
Input Impedance: 10 Mn IExternal Input).
Input ProtectIon: i3ov "lax +mvered), il5V "lax (u"powerd).
Input Coupling: ACorDC
Trlggcr Slope: Rlslng or Falling Edge.
Input Filter: Software selectable single pole low pass filter with the following characteristics:
-3db Frequency 5ettling time to l/2 l.SB
1 MHz
3ookHz
ml kHz
30 kHz
10 kHz
3 kHz
1 kHz
XXI Hz
OUtpUt: 1.) L&v-true h'igger signal to motherboard connector for triggering AMMI A or AMM2 in
adjjcent slot, and/or; 2.) interrupt request (IRQ) to host computer; 3.) atus wgister.
IRQ is open collector low-tme pulse 500 nS typical. A/D hiaer signal is software
selectable 1obe either a 5Kl nS low-hue pulse, or a low-true level.
Signal Co""ecuon: J-pin quick disconnect screw terminal block for external input. Cable to AMM card for
global amp connection supplied.
Note: The TRGI requires a +lOVref~cesi~al to bepresent on the backplane, which is typically provided by
an AhfMl.4 or AMMZ module used in Slot 1. If one TRGl is used in 0 system, it must be placed in Slot
2. ff two TRCl modules are used in a system, they must be used in Slots 2 and 3.
TR REVISIONS APP. DATE DRN.A-J.5 DATEol2-m
U9.d Kalthtq t"~bunwnu Inc.
4 RELEASED'13713 10-12~99CKD. DATE Cleveland. Ohio 44139
- APP. DATE
IPT IlllMR~~
SPECIFICATIONS -
I 500-TRG I
I I