Text preview for : 14PV365-01. service mode info.pdf part of Philips 14PV365-01. service mode info Philips TV 14PV365-01. service mode info.pdf
Back to : 14PV365-01. service mode | Home
[ 14PV111/ ( 01, 07, 58 ), 14PV112/ ( 07, 39 ), 14PV203/ ( 01, 07, 39, 58 ),
14PV415/ ( 01, 07, 39, 58 ), 14PV460/ ( 01, 07, 39, 58 ) ]
General Note:
"CBA" is abbreviation for "Circuit Board How to set up the option code
Assembly."
1. Enter the Service mode.
2. Press the [STATUS/EXIT] button on the remote
NOTE: control unit. The option code appears on the dis-
Electrical adjustments are required after replacing play.
circuit components and certain mechanical parts. 3. If needed, input the option code as shown below
It is important to perform these adjustments only using number buttons on the remote control unit.
after all repairs and replacements have been com-
pleted. Model Option Code
Also, do not attempt these adjustments unless the
proper equipment is available. 14PV111(112)(415)/07 000128
14PV112(415)/39 000129
14PV111(415)/01 000130
Test Equipment Required
14PV111(415)/58 000131
1. PAL Pattern Generator (Color Bar W/White Win-
14PV203(460)(465)/01 000158
dow, Red Color, Dot Pattern, Gray Scale,
Monoscope, Multi-Burst) 14PV203(460)(465)/07 000156
2. AC Milli Voltmeter (RMS) 14PV203(460)(465)/39 000157
3. Alignment Tape (FL6A), Blank Tape 14PV203(460)(465)/58 000159
4. DC Voltmeter 4. To reset the software, press [PAUSE] and [5] but-
5. Oscilloscope: Dual-trace with 10:1 probe, tons on the remote control unit.
V-Range: 0.001~50V/Div, The option code is changed.
F-Range: DC~AC-60MHz
6. Frequency Counter
7. Plastic Tip Driver
How to Set up the Service mode:
NOTE:
After replacing the IC202 ( Memory ) or Main CBA,
the set value in IC202 ( Memory ) will be lost. So it
is necessary to set up or adjust in the Service
mode after its replacement.
Service Mode:
1. Turn the power on. (Use main power on the TV
unit.)
2. Press [STANDBY/ON], [2], [7], [1], and [MUTE]
buttons on the remote control unit in that order
within 5 seconds.
- To cancel the service mode, press [STANDBY/ON]
button on the remote control.
1-6-9 T6310EA