| Make | Model | Problem | Solution | Date |
| | | |
| Found: 12
|
| Ferguson | ICC19 Thomson 32WS83KP | starts up then trips and shuts down | IB01 TEA5101B on CRT | 14-09-04 |
| Ferguson | TX807 Thomson 14MS15UT | dead, no LED | DP25 RGP10 s/c | 14-09-04 |
| Ferguson | TX91 Thomson 10MH73B 10MG73B | dead | SMD TF21 near LOPTx not soldered in factory | 14-09-04 |
| Ferguson | TX91 Thomson 10MH73B 10MG73B | dead on 12V supply (car supply) | RD09, RD19 22R 0.5W fusible | 14-09-04 |
| Hitachi | C2874TH | Rolling pic when warm | FOP stage supply 4v high at 29v. R952 68k in HT sampling circuit hi res | 14-09-04 |
| Mitsubishi | AV1 srs WITH SAT | BLANK RASTER OSD OK. | Z953 1.6A OC DUE TO LNB SHORTED - UPRATE TO 3.15A Pt No 299P193030 | 14-09-04 |
| Nordmende | F9 Chassis (Control board with SAA1121/SAA1130/SAA1020) | Snow on screen, all leds lit, stuck on UHF band. | Change SAA1121. | 14-09-04 |
| Saba | S Chassis withMTS2020SM Tuner | Int. snow with no picture.Seems to be DJs. | Replace 1nF SMD capacitor connected between pins 3 and 4 of SDA2101 | 14-09-04 |
| Siemens/Blaupunkt | Chassis100/21 (Control section with hybrid Siemens Ics) | Set can not be switched to Stby with the remote control. All other functions O.K | Switch the TV to Stby from the on/Stby switch on the front panel.Hold down the"ME" button and switch the TV on.Press CS. It should work normally now. | 14-09-04 |
| Siemens/Blaupunkt | Chassis100/21 (Control section with hybrid Siemens Ics) | To set normal values for Bright/Contr/Col/Volume | Switch set to Stby. Hold down "ME"button, until set switches on. Adjust bright,contr etc and press "ME" again to memorise. | 14-09-04 |
|
|
| Siemens/Blupunkt | Chassis100/21 (Control section with hybrid Siemens Ics) | Set can not be switched to Stby with the remote control. All other functions O.K | Switch the TV to Stby from the on/Stby switch on the front panel.Hold down the"ME" button and switch the TV on.Press CS. It should work normally now. | 14-09-04 |
| Siemens/Blupunkt | Chassis100/21 (Control section with hybrid Siemens Ics) | To set normal values for Bright/Contr/Col/Volume | Switch set to Stby. Hold down "ME"button, until set switches on. Adjust bright,contr etc and press "ME" again to memorise. | 14-09-04 |