| Make | Model | Problem | Solution | Date |
| | | |
| Found: 901
|
| Hitachi | CPT2888 | NO PICTURE , SOUND BUZZES FOR 10 - 30mins THEN OK | CP37 U1 7v RESERVOIR OC | 14-09-04 |
| Hitachi | CPT5908 | Dead or Int dead | Check C524 C525 C527 C528 C531 C614 C617 for D/J also TR130 IC130 IC140 & around Combi TX | 14-09-04 |
| Hitachi | CPT6608 | Dead or Int dead | Check C524 C525 C527 C528 C531 C614 C617 for D/J also TR130 IC130 IC140 & around Combi TX | 14-09-04 |
| Hitachi | CS1415RE | Dead - PSKE130 prot diode s/c due to excessive HT | Won't run on dummy load - has 220v HT off load; Q 951 BF422 Leaky Base Em. | 14-09-04 |
| Hitachi | CS2543TAN | Dead - LOTr T511 S2000AF has short life | Check scan coil conns for arcing/dry joints - also may be caused by Nicam module upsetting I2C bus line in turn causing line osc to lose sync - can remove NICAM module to check | 14-09-04 |
| Hitachi | CS2552TA | no cold start | C622 470µ 16v | 14-09-04 |
| Hitachi | CT1709 | No sigs or tuning | No VT supply - ZD002 33v zener faulty & 12k feed res o/c | 14-09-04 |
| Hitachi | CT2114TE | Int goes to st/by with HT present & fop ok | Also int txt corrupt & 9v start up - SAA5296P/015 µ faulty | 14-09-04 |
| Hitachi | CTP2568 | Int failed to come out of st/by | 1.2v memory battery on mains I/p panel | 14-09-04 |
| Hitachi | G10 C2564TN | Line tearing/ringing type effect | Check final anode cap for arcing | 14-09-04 |
|
|
| Hitachi | G10Q | CRACKLING FROM SPKRS | IC4010 INT OC | 14-09-04 |
| Hitachi | G10Q | Dead apart from tripping squeal | E-W coil L650 dry joint, F902 o/c & D704 leaky | 14-09-04 |
| Hitachi | G10Q | Dead except for flashing st/by light | No 330v at chopper tr as link FB910 dry joints (hidden under glue) - also check FB911 | 14-09-04 |
| Hitachi | G10Q | DEAD STBY LIGHT PULSING | LINK FB910 & 911 DRY UNDERNEATH GLUE | 14-09-04 |
| Hitachi | G10Q | FAINT PURPLE BAND SHOWING ON DARK SCENES | DL50 DELAY LINE Pt No 2164051 | 14-09-04 |
| Hitachi | G10Q | Field collapse | Check C604 100µ 63v, R609 1R fusible & IC601 TDA8178 - use correct type or you may get lines at top of pic | 14-09-04 |
| Hitachi | G10Q | No Txt apart from page number display | Adj data capture window in service mode | 14-09-04 |
| Hitachi | G10Q | OSG corrupt & int loss of tuning | Micro IC001 faulty - when upgrading micro, mods must be done | 14-09-04 |
| Hitachi | G10Q | Poor start or st/by only | Dry joints IC952 (under plastic rail) | 14-09-04 |
| Hitachi | G10Q | St/by LED pulsing | OPTO1 CNX82 part no T548009 | 14-09-04 |
| Hitachi | G10Q | To enter Service Mode | Press Vol + & - together whilst sw on from mains. Press the 2 VCR Rec buttons on hset together twice - 'Tube' now displayed | 14-09-04 |
| Hitachi | G10Q | Tripping | Check F902 630mA fuse on LOP panel & dry joints & IC80 heatsink on crt base | 14-09-04 |
| Hitachi | G10Q | Tripping | Check audio pcb by disconnecting it | 14-09-04 |
| Hitachi | G10Q | trips until heated | C927 470µ & dry joints 12v reg IC921 | 14-09-04 |
| Hitachi | G10Q | trips until heated | ZD945 BZV10 - normally reads o/c both ways | 14-09-04 |
| Hitachi | G10Q C2564 | Int start up | C927 470µ 25v in 12v line | 14-09-04 |
| Hitachi | G10Q C2564 etc | Repeated failure of E/W diode D704 BY228 which causes tripping & blowing fuse F902 | Also replace Q651 BU801 pt no T636046 & Q652 BC548B, L651 filter coil pt no 2220642 (goes shorted turns) | 14-09-04 |
| Hitachi | G6P | BLANK RASTER , NO SOUND | C933 2200mfd , 25v ALSO CHECK 12v REG OP. IC932 | 14-09-04 |
| Hitachi | G6P | Blank raster, no sound | IC932 12v reg o/p low, C933 2200µ 25v | 14-09-04 |
| Hitachi | G6P | Blank white raster with fb lines | Q301 2SA673C s/c,replacement restored pic but no OSD & red fb lines; M50450-023P micro | 14-09-04 |