| Make | Model | Problem | Solution | Added | Date |
| | | | |
| Found: 182 |
| Goldstar | 20A80 | No picture. | FR406 OC ( NO FIELD ) | plamensl | 14-09-2004 |
| Goldstar | 20A80AF | Int reverts to st/by & won't come back on | Sw mode tfmrT801 int o/c HT winding pt no 151-148A | plamensl | 14-09-2004 |
| Goldstar | 2168F | FIELD CRAMP , LINE ACROSS SCREEN | C309 ( TANT ) 0.22mfd | plamensl | 14-09-2004 |
| Goldstar | C1I20C22F CI21C22F | No response to R/C or front controls | Replace C814 & Q811 | plamensl | 14-09-2004 |
| Goldstar | CB14A80E | Reduced width. 6-8 volts on supply pin of TDA8362 | Replace TDA8362. Supplying +12V to supply pin of TDA8362, restored width but with no hor. Synchronization. | plamensl | 14-09-2004 |
| Goldstar | CB14A80E | Reduced width. 6-8 volts on supply pin of TDA8362 | Replace TDA8362. Supplying +12V to supply pin of TDA8362, restored width but with no hor. Synchronization. | plamensl | 14-09-2004 |
| Goldstar | CB14A80E | Relay goes on, then off, immediately after switch on | Change memory chip St24C02C. | plamensl | 14-09-2004 |
| Goldstar | CBZ9222E | No horizontal sync. when cold. When hot, everything is OK. It was not possible to track the defective component with a freezer spray. | Changed several caps around TDA2579 chip. | plamensl | 14-09-2004 |
| Goldstar | CBZ9222E | No horizontal sync. when cold. When hot, everything is OK. It was not possible to track the defective component with a freezer spray. | Changed several caps around TDA2579 chip. | plamensl | 14-09-2004 |
| Goldstar | CF25C22F | Width excessive with bowing | C413 10µ 250v u/s caused by C405 0µ22 low cap | plamensl | 14-09-2004 |
| Goldstar | CF25C22F CF28C22 | DEAD SET , RELAY CHATTERS , D401 SC | CHANGE , R308 - 33R 3W ORSO322L667 , D401 , D402 - RU4DS ODD400000AB , X501 - 156-A05B . ALSO CHECK IC301 , ZD304 . | plamensl | 14-09-2004 |
| Goldstar | CF25C22F CF28C22F | Dead - no line drive - 150v HT ok | SCL & SDA missing at pins 4 & 5 IC503. Replace X01N on Nicam pcb or IC03N if that doesn't cure it | plamensl | 14-09-2004 |
| Goldstar | CF25C22F CF28C22F | Dead Q801 chopper tr s/c | Reduce R810 from 12k to 6k8 | plamensl | 14-09-2004 |
| Goldstar | CF25C22F CF28C22F | Dead with relay chattering | Change R308 to 33R 3w, D401/402 to RU4DS & X501 to pt no 156-A05B | plamensl | 14-09-2004 |
| Goldstar | CF25C28CF | Field collapse | Fit kit which contains TDA8350QN5 (don't use TDA8350Q) | plamensl | 14-09-2004 |
| Goldstar | CF25C28F | E-W Dist | Q351 KTB988Y s/c e-c & FR359 22R ?w fus res high | plamensl | 14-09-2004 |
| Goldstar | CF25C28F | Field collapse | IC351 TDA8350Q & mod kit KITPC58A | plamensl | 14-09-2004 |
| Goldstar | CF25C36 NC51B | Wont stop when in search - existing chans may be slightly off tune | IC182 5v reg producing low o/p | plamensl | 14-09-2004 |
| Goldstar | CF28A50 PC58A | Field - dist top edge of pic | Check electrolytics in field stage & fop chip IC351 TDA8350Q | plamensl | 14-09-2004 |
| Goldstar | CF28C22F | Dead - all psu volts present - lop tr hot | C405 0µ22 400v bulged & leaky (checked ok out of cct) | plamensl | 14-09-2004 |