Samsung SyncMaster570sTFT free download

File name SAMSUNG SyncMaster570sTFT.pdf

COLOR MONITOR SyncMaster 570sTFT (CN15LS*) SyncMaster 580sTFT (CN15LO*) SERVICE COLOR MONITOR AUTO EXIT MENU Manual CONTENTS 1. Precautions 2. Product Specifications 3. Disassembly & Reassembly 4. Troubleshooting 5. Exploded View & Parts List SyncMaster 570sTFT 6. Electrical Parts List 7. Block Diagram 8. Wiring Diagram 9. Schematic Diagrams AUTO EXIT MENU SyncMaster 580sTFT Samsung Electronics Co., Ltd. May 2000. Printed in Korea P/N. : BN68-00097C-01 1 Precautions Follow these safety, servicing and ESD precautions to prevent damage and to protect against potential hazards such as electrical shock. 1-1 Safety Precautions 1-1-1 Warnings 1. 2. 3. For continued safety, do not attempt to modify the circuit board. Disconnect the AC power and DC Power Jack before servicing. When the chassis is operating, semiconductor heatsinks are potential shock hazards. DEVICE UNDER TEST TEST ALL EXPOSED METAL SURFACES (READING SHOULD NOT BE ABOVE 0.5mA) LEAKAGE CURRENT TESTER 1-1-2 Servicing the LCD Monitor 1. When servicing the LCD Monitor, remove the static charge by connecting a 10k ohm resistor in series with an insulated wire (such as a test probe) between the chassis and the anode lead. (Disconnect the AC line cord from the AC outlet.) It is essential that service technicians have an accurate voltage meter available at all times. Check the calibration of this meter periodically. 2-WIRE CORD ALSO TEST WITH PLUG REVERSED (USING AC ADAPTER PLUG AS REQUIRED) EARTH GROUND 2. Figure 1-1. Leakage Current Test Circuit 4. With the unit completely reassembled, plug the AC line cord directly into a 120V AC outlet. With the unit's AC switch first in the ON position and then OFF, measure the current between a known earth ground (metal water pipe, conduit, etc.) and all exposed metal parts, including: metal cabinets, screwheads and control shafts. The current measured should not exceed 0.5 milliamp. Reverse the power-plug prongs in the AC outlet and repeat the test. 1-1-3 Fire and Shock Hazard Before returning the monitor to the user, perform the following safety checks: 1. Inspect each lead dress to make certain that the leads are not pinched or that hardware is not lodged between the chassis and other metal parts in the monitor. Inspect all protective devices such as nonmetallic control knobs, insulating materials, cabinet backs, adjustment and compartment covers or shields, isolation resistor-capacitor networks, mechanical insulators, etc. Leakage Current Hot Check (Figure 1-1): WARNING: Do not use an isolation transformer during this test. Use a leakage current tester or a metering system that complies with American National Standards Institute (ANSI C101.1, Leakage Current for Appliances), and Underwriters Laboratories (UL Publication UL1410, 59.7). 2. 1-1-4 Product Safety Notices Some electrical and mechanical parts have special safety-related characteristics which are often not evident from visual inspection. The protection they give may not be