Panasonic KX-TCD962HGB free download

File name KX-TCD962HGB.pdf

ORDER NO. KM40010719C2 Telephone Equipment KX-TCD962HGB Digital Cordless Phone (for Hungary) SPECIFICATIONS 1 1 1. LOCATION OF CONTROLS BASE UNIT Fig. 1 2 HANDSET Fig. 2 3 4 2. DISASSEMBLY INSTRUCUTIONS 5 3. SETTINGS 6 3.1. Installing the Batteries In the Handset Install the batteries as shown. Then install the handset cover. - If the rechargeable batteries are not inserted correctly, the handset will not work. 3.2. Connection Plug in the AC adaptor and the telephone line cord to the bottom of the unit. Then connect the cords as shown. 7 - USE ONLY WITH Panasonic AC ADAPTOR KX-TCA11CE. - Be careful not to confuse the telephone line jack with the AC adaptor jack on the base unit. If connected improperly, the base unit will not work and damage may occur. - The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.) - The unit will not work during a power failure. We recommend you connect a standard telephone on the same line for power protection. - If your unit is connected to a PBX which does not support Caller ID services, you cannot access those services. 3.3. Battery Charge 8 3.4. Installing the Handset Clip 9 You can hang the handset on your belt or pocket using the belt clip. 3.5. Selecting the Dialing Mode You can program the dialing mode to tone or pulse. If you have touch tone service, set to tone. If rotary or pulse service is used, set to pulse. The factory preset is tone. Make sure that the power is ON and the unit is in the stand-by mode. 4. OPERATIONS 4.1. Making Calls 4.1.1. Turning the Power On 10 4.1.2. To Dial After Confirming the Entered Number 11 4.1.3. To Redial the Last Number Dialed 4.1.4. To Redial After Confirming the Numbers In Redial Memory 12 4.1.5. To clear all numbers in the redial memory 4.2. Answering Calls 13 4.3. Setting the Receiver Volume 14 4.4. Selecting the Handset Ringer Volume You can program the desired handset ringer volume. Make sure that the power is on and the unit is in the stand-by mode. 6 levels are available. The lowest level is 1. The highest level is 6. The factory preset is 3. When set to OFF, the handset will not ring. 15 4.5. SELECTING THE BASE UNIT RINGER VOLUME 4 levels (HIGH, MEDIUM, LOW, OFF) are available. The factory preset is MEDIUM. When set to OFF, the base unit will not ring. 16 4.6. Greeting Message You can record a personal greeting message. If a greeting message is not recorded, one of two pre-recorded greeting will be played when a call is received. All messages (greeting, incoming, memo, etc.) are stored in digital memory. The total recording time is about 14 minutes. The greeting recording time is limited to 2 minutes and 30 seconds. We recommend you record a brief greeting message (see the sample below) in order to leave more time for recording new messages. 4.6.1. To Record a Greeting Message 17 4.6.2. To Adjust the Speaker Volume (9 levels) 4.6.3. To Erase a Recorded Greeting Messag