AIWA CT-R411 free download

File name CTR 411-421-431 Rev.pdf

CT-R411 CT-R421 CT-R431M CT-X4310M YZ(ST) YZ(ST) YZ(ST) YL(ST) SERVICE MANUAL STEREO CAR CASSETTE RECEIVER BASIC TAPE MECHANISM : CDS-363AG1-A S/M Code No. 09-012-354-5N3 DA TA SPECIFICATIONS RADIO SECTION (FM) Frequency Range: 87.5 MHz ­ 108 MHz (50-kHz steps) Usable Sensitivity: 12.7 dBf 50 dB Quieting Sensitivity: 17.2 dBf IF Rejection: 80 dB Frequency Response: 30 Hz ­ 15,000 Hz S/N Ratio: 63 dB Stereo Separation: 35 dB at 1 kHz Alternate Channel Selectivity: 70 dB Capture Ratio: 3 dB RADIO SECTION (FM) Frequency Range: 87.5 MHz ­ 108 MHz (100-kHz steps)* or 87.5 MHz ­ 108 MHz (50-kHz steps)* Usable Sensitivity: 12.7 dBf 50 dB Quieting Sensitivity: 17.2 dBf IF Rejection: 80 dB Frequency Response: 30 Hz ­ 15,000 Hz S/N Ratio: 63 dB Stereo Separation: 35 dB at 1 kHz Alternate Channel Selectivity: 70 dB Capture Ratio: 3 dB (MW) Frequency Range:531 kHz­1,602 kHz (9-kHz steps) Usable Sensitivity: 30 µV (30 dB) (AM) Frequency Range: 530 kHz ­ 1,710 kHz (10-kHz steps)* or 531 kHz ­ 1,602 kHz (9-kHz steps)* Usable Sensitivity: 30 µV (30 dB) 9k 10 k * Set the frequency increment for your area using the switch on the bottom of the unit. (The switch is factory-set to the 10 k position) (LW) Frequency Range:144 kHz ­ 288 kHz (1-kHz/9-kHz steps) Usable Sensitivity: 30 µV (30 dB) TAPE SECTION Tape Speed: 4.8 cm/sec. (1 7/8 ips) S/N Ratio: 50 dB Frequency Response: 40 Hz ­ 14,000 Hz Stereo Separation: 40 dB TAPE SECTION Tape Speed: 4.8 cm/sec. (1 7/8 ips) S/N Ratio: 50 dB Frequency Response: 40 Hz ­ 14,000 Hz Stereo Separation: 40 dB AUDIO SECTION Max. Power Output: 40 W x 4 channels AUDIO SECTION Max. Power Output: 40 W x 4 channels AUX IN input Input sensitivity (load impedance) AUX IN: 300 mV (10 k ) AUX IN input Input sensitivity (load impedance) AUX IN: 300 mV (10 k ) GENERAL Power-Supply Voltage: 14.4 V (11 to 16 V allowable), DC, negative ground Load Impedance: 4 Tone Control: Bass ± 10 dB at 100 Hz, Treble ± 10 dB at 10 kHz Preamp Output Voltage (load impedance): 2.2 V (10 k ) Installed size: 182 (W) x 53 (H) x 155 (D) mm (7 1/4 (W) x 2 1 /8 (H) x 6 1/8 (D) inches) GENERAL Power-Supply Voltage: 14.4 V (11 to 16 V allowable), DC, negative ground Load Impedance: 4 Tone Control: Bass ± 10 dB at 100 Hz, Treble ± 10 dB at 10 kHz Preamp Output Voltage (load impedance): 2.2 V (10 k ) Installed size: 182 (W) x 53 (H) x 155 (D) mm (7 1/4 (W) x 2 1 /8 (H) x 6 1/8 (D) inches) · Design and specifications are subject to change without notice. -2- ACCESSORIES LIST REF. NO 1 1 2 2 3 4 5 6 7 8 9 10 11 12 13 KANRI DESCRIPTION NO. 8B-KTF-902-010 IB,YL(3L) 4310M 8B-KTA-901-010 IB,YZ(9L) R431M,421,411 8B-KT9-902-010 IB,INST,YU,YL (3L,P)-C 8B-KT9-904-010 IB,INST,YZ,YV (9L,R)-C 8Z-KC1-235-010 HLDR,REAR MTG 8Z-KC1-231-110 8B-KTG-608-010 8Z-KC1-030-010 8Z-KC1-232-010 87-B10-141-010 8Z-KC1-244-010 8Z-KC1-250-010 87-B10-143-010 87-B10-144-010 87-B10-145-010 HLDR,HALF -C CONN ASSY,16P SSS CASE,DFP -C KEY,REMOVE -