Pioneer AVIC-D1 free download

File name AVIC-D1.pdf

ORDER NO. CRT3466 AVIC-D1/UC DOUBLE-DIN DVD NAVIGATION SYSTEM AVIC-D1 Model No. CX-3016 CX-3158 /UC This service manual should be used together with the following manual(s): Order No. CRT3056 CRT3394 Mech.Module MS3 S10.1AAC Remarks DVD Mech. Module:Circuit Description, Mech. Description, Disassembly CD Mech. Module:Circuit Description, Mech. Description, Disassembly This product has the unit part number as below. Unit Part No. CPN1951 Description Navigation Unit *) The unit part numbers listed above are not for the service components. For details, refer to "Important Check Points for Good Servicing". PIONEER CORPORATION 4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan PIONEER ELECTRONICS (USA) INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A. PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936 PIONEER CORPORATION 2005 K-ZZW. APR. 2005 Printed in Japan 1 2 3 4 SAFETY INFORMATION CAUTION A This service manual is intended for qualified service technicians; it is not meant for the casual do-it-yourselfer. Qualified technicians have the necessary test equipment and tools, and have been trained to properly and safely repair performed If you are not qualified to can adversely affect the and reliability of the product and may void the . the repair of this product properly and , you should not risk trying to do so W WARNING This product contains lead in solder and certain electrical parts contain chemicals which are known to the state of B Health & Safety Code Section 25249.6 - Proposition 65 This product contains mercury. Disposal of this material may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronics Industries Alliance: www.eiae.org. - Service Precautions 1. You should conform to the regulations governing the product (safety, radio and noise, and other regulations), and should keep the safety during servicing by following the safety instructions described in this manual. C DVD MECHANISM MODULE section precaution 1. EJECT LOCK MODE for DVD mechanism In order to enter "EJECT LOCK" mode, reset start while pressing the "AV" and "INFO" keys together. Pressing the "AV" and "INFO" keys until monitor backlight is turned on. In order to exit "EJECT LOCK" mode, follow the same steps to enter this mode. 2. Before disassembling the unit, be sure to turn off the power. Unplugging and plugging the connectors during power-on mode may damage the ICs inside the unit. 3. To protect the pickup unit from electrostatic discharge during servicing, take an appropriate treatment (shorting-solder) by referring to "the DISASSEMBLY" . 4. After replacing the pickup unit, be sure to skew adjustment. 5. During disassembly, be sure to turn the power off since an internal IC might be destroyed when a connector is plugged or unplugged. CD MECHANISM MODULE sec