Samsung ML-1510 free download

File name Samsung ML-1510 Disassemb.pdf

Disassembly and Reassembly 5 5. Disassembly and Reassembly 5.1 General Precautions on Disassembly Releasing Plastic Latches Many of the parts are held in place with plastic latches. The latches break easily; release them carefully. To remove such parts, press the hook end of the latch away from the part to which it is latched. When you disassemble and reassemble components, you must use extreme caution. The close proximity of cables to moving parts makes proper routing a must. If components are removed, any cables disturbed by the procedure must be restored as close as possible to their original positions. Before removing any component from the machine, note the cable routing that will be affected. Whenever servicing the machine, you must perform as follows: 1. Check to verify that documents are not stored in memory. 2. Be sure to remove the toner cartridge before you disassemble parts. 3. Unplug the power cord. 4. Use a flat and clean surface. 5. Replace only with authorized components. 6. Do not force plastic-material components. 7. Make sure all components are in their proper position. Service Manual Samsung Electronics 5-1 Disassembly and Reassembly 5.2 Top Cover 1. Pull the Cassette out of the printer. 4. Unlatch the front ends of the Top Cover. Cassette 2. Remove the Front Cover in the direction of arrow. 5. Remove the Top Cover in the direction of arrow. Top Cover Front Cover 3. Remove four screws. 6. Remove the Rear Cover from the Top Cover. Rear Cover 5-2 Service Manual Samsung Electronics Disassembly and Reassembly 5.3 Fuser 5.3.1 Fuser(Heat Lamp Type) 1. Before you remove the Fuser, you should remove: - Top Cover(see page 5-2) 2. Unplug two connectors(Block) from the boards, then remove four screws. 5. Remove one screw and take the Idle Gear out. Idle Gear Fuser Ass'y 6. Remove four screws and divide the Fuser into two parts Fuser Cover 3. Remove two screws and take the Thermostat out of the Fuser. Thermostat 4. Remove two screws and take the Halogen Lamp out of the Heat Roller. Heat Roller 7. Remove the Thermister from the Fuser Cover. Thermister Halogen Lamp Service Manual Samsung Electronics 5-3 Disassembly and Reassembly 5.3.2 Fuser(Q-PID Type) 1. Before you remove the Fuser, you should remove: - Top Cover(see page 5-2) 2. Unplug two connectors(Block) from the boards, then remove four screws. 4. Remove two screws. Fuser Ass'y 5. Remove one screw and take the Idle Gear out. Idle Gear 3. Remove two screws and take the Thermostat out of the Fuser. Thermostat 5-4 Service Manual Samsung Electronics Disassembly and Reassembly 6. Separate Heat Roller Ass'y after remove six screws and after removing 6 screws as shown in below, take out the heat roller assembly in direction of the arrow while pulling the both side of the unit-brush 7. Unplug Thermister Harness from the Fuser cover. Thermister Harness Fuser Cover Unit-Brush Heat Roller 8. Remove one screw and separate Thermister from the inter conn