Panasonic DP-3010 free download

File name DP-3010 Service Manual.pdf

Order Number: MGCS040801C0 H21 Digital Imaging Systems DP-2310/3010 DP-2330/3030 [ Version 2.1 ] WARNING This service information is designed for experienced repair technicians only and is not intended for use by the general public. It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product. Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any attempt to service or repair the product or products dealt within this service information by anyone else could result in serious injury or death. © 2005 Panasonic Communications Co., Ltd. All rights reserved. Unauthorized copying and distribution is a violation of law. This Product Uses Lead (Pb) Free Solder Printed Circuit Boards (PCBs). Information regarding Lead-Free (PbF) solder: Distinction of PbF PCB: PCBs (manufactured) using lead free solder will have a mark following the PCB part numbers in a label on the PCB. Caution: Pb free solder has a higher melting point than standard solder; typically the melting point is 50 - 70 F (30 - 40 C) higher. Please use a soldering iron with temperature control and adjust it to 700 20 F (370 10 C). Exercise care while using higher temperature soldering irons, do not heat the PCB for too long to prevent solder splash or damage to the PCB. Pb free solder will tend to splash when heated too high (about 1100 F/600 C). ECO SOLDER M705 (available from Senju Metal Industry Co., Ltd.: URL: http://www.senju-m.co.jp) is recommended when repairing PbF PCBs. The contents of this Service Manual and the Specifications are subject to change without notice. Panasonic Communications Co., Ltd. reserves the right to make improvements in the product design without reservation and without notice. Published in Japan. 2 Important Notice Please read this notice completely BEFORE installing any optional accessories. As failure to properly install the additional board or connector with the power ON (only the front power switch Off) could damage the copier's SPC or SC board. Please follow the instructions below: 1. It is essential that you turn OFF power to the Main Power Switch located in the rear of the copier. 2. It is essential that you unplug the Main AC Power Cord from the wall outlet. 3. Please carefully read the installation instructions and follow each step. Note: If the Hard Disk Drive Unit is installed, to prevent a Disk Scan Function from being performed (similar to Windows OS when the power is abruptly interrupted), it is important to follow the step sequence below when turning OFF the Power Switches on the machine. 1. Turn the Power Switch on the Left Side of the machine to the OFF position first. 2. Wait approximately 10 seconds while the machine writes the closing status onto the Hard Disk Drive Unit. 3. Turn the Main Power Switch on the Back of the machine to the OFF position. (This interrupts all the