Yamaha 03D free download

File name 03D_LSI_C.pdf

File name 03D_Main_C.pdf

File name 03D_MIDI_C.pdf

File name 03D_Parts_C.pdf

File name 03D_PCB1_C.pdf

File name 03D_PCB2_C.pdf

File name 03D_TestE_C.pdf

File name 03D_TestJ_C.pdf

File name Yamaha-03D(own) mixer.pdf

Revision #03 Editware Technical Note TECH NOTE Fastrack VS Version 2.1 and later YAMAHA 03D SERIAL AUDIO MIXER The Fastrack VS hybrid editing system interfaces to the 03D Serial Audio Mixer with a 6-pin DIN to 9-pin RS-422 serial control cable and Yamaha 03D audio mixer serial protocol. Direct control of each individual fader and the learning of manual adjustments are possible. Page 1 of 7 02/07/2003 Fastrack VS and the Yamaha 03D Audio Mixer Revision #03 Editware Technical Note Interconnect Cable An interconnect cable can be constructed using a PS-2 mouse/keyboard plug and wire and a Serial RS-422 female connector. This cable connects between the HOST port on the Yamaha O3D and a serial (male-male) cable attached to the Fastrack serial breakout (or use a male connector if your cable is long enough to reach the Fastrack serial breakout). Since the numbering on PS-2 connectors varies or is frequently missing, please refer to the letter positions noted here for the PS-2 plug (the 9-pin conforms to standards). Both 9-pin connector and PS-2 plug are viewed from the "front." Serial 9-pin 2 7 3 8 PS-2 plug E F A B C & D jumpered Note: The jumper between the top two pins on the PS-2 plug is essential for status reporting from the 03D mixer to Fastrack so it can "learn" manual changes to fader levels. Page 2 of 7 02/07/2003 Fastrack VS and the Yamaha 03D Audio Mixer Revision #03 Editware Technical Note Mixer Setup 1. Connect the serial control cable from a Fastrack VS "COM" or "P#" port to the 6-pin "TO HOST" serial port on the rear of the 03D console. 2. At the 03D control panel "SETUP" section (top, left of the mixer), press the [UTILITY] button until the "MIDI / HOST" tab is selected. 3. At the "MIDI / HOST" tab, use the cursor buttons (under the PARAMETER wheel) to select, and then press the [ENTER] button, to accept the following: Rear view of the 03D panel Optional AES YGADI inputs/outputs (not shown) would be at lower right of above image. Page 3 of 7 02/07/2003 Fastrack VS and the Yamaha 03D Audio Mixer Revision #03 Editware Technical Note Monitoring to amplifier and speakers is from the MONITOR OUT (1/4" TRS) connections Program Out is from the ST OUT (XLR) connections Analog inputs 1-8 use balanced XLR connections Analog inputs 9-16 use 1/4" TRS (tip/ring/sleeve) connections. Monitor outs uses 1/4" TRS connections. Bus outs use 1/4" TRS connections. ST Out uses XLR and is the PROGRAM OUT to any/all record channels. MONITORING The 03D has a monitoring bus that can be remotely controlled as a preview bus; therefore, all audio previews should be done utilizing this preview switcher in the 03D. Set each source's BUS Out and monitoring in the [PAN/ROUTE] section as below for four channels per source: The BUS Outputs (1-4) are fed to the RECORD device for recording (or AES Out if the YGADI option is installed) and the MONITOR OUT connected to amplifier and speakers. The ST OUT is the signal that is monitored on the MONITO