Sony DPA-300 free download

File name sony_DPA-300_service_manual.pdf

DPA-300 SERVICE MANUAL US Model Canadian Model U.S and foreign patents licensed from Dolby Laboratories Licensing Corporation. Model Name Using Similar Mechanism MD Mechanism Type Base Unit Name Optical Pick-up Name NEW MDM-2BR MBU-2 KMS-210A/J-N SPECIFICATIONS System Recording format Picture MD recording system Data compression/saving system JPEG FINE mode : 128kB (the maximum 1,000 images) STANDARD mode : 64kB (the maximum 2,000 images) Revolutions 400 rpm to 900 rpm (CLV) Error correction Advanced Cross Interleave Reed Solomon Code (ACIRC) Laser Semiconductor laser ( = 780 nm) Emission duration : continuous Laser output Max 44.6 µW * This output is the value measured at a distance of 200 mm from the objective lens surface on the Optical Pick-up Block with 7 mm aperture. Sampling frequency 44.1 kHz Coding Adaptive TRansform Acoustic Coding (ATRAC) Modulation system EFM (Eight to Fourteen Modulation) Number of channels 2 stereo channels Input VIDEO INPUT Input signal : 1Vp-p (75 unbalanced) Y/C INPUT, Mini DIN 4-pin Luminance signal : 1Vp-p (75 unbalanced) Chrominance signal : 0.286 Vp-p (75 unbalanced) AUDIO IN (L/R) Input level : 2 Vrms (full bit) Input impedance : more than 47 k FS1/FS2 (RED/WHITE) connectors VIDEO OUTPUT Output signal : 1 Vp-p (75 unbalanced) Y/C OUTPUT, Mini DIN 4-pin Luminance signal : 1 Vp-p (75 unbalanced) Chrominance signal : 0.286 Vp-p (75 unbalanced) AUDIO OUT (L/R) Output level : 2 Vrms (full bit) Output impedance : more than 47 k Output -- Continued on next page -- DIGITAL STILL RECORDER MICROFILM SAFETY CHECK-OUT General Power requirements Sony AC Power Adaptor AC-DA300 (supplied) connected at the DC IN 12 V jack : 120V AC, 60Hz (US model) Power consumption 20 W Operating temperature 5 °C to 35 °C (41°F to 95°F) Operating humidity 30% to 85% Dimensions Approx. 280 Ч 80 Ч 290 mm (111/8 Ч 31/4 Ч 111/2 inches) (w/h/d, including projecting parts and controls) Mass Approx. 2.5 kg (5 lb. 8 oz) Supplied accessories AC power adaptor AC-DA300 Remote commander RMT-DA300 (1) Size AA (R6) batteries (2) Design and specifications are subject to change without notice. After correcting the original service problem, perform the following safety checks before releasing the set to the customer: Check the antenna terminals, metal trim, "metallized" knobs, screws, and all other exposed metal parts for AC leakage. Check leakage as described below. LEAKAGE The AC leakage from any exposed metal part to earth ground and from all exposed metal parts to any exposed metal part having a return to chassis, must not exceed 0.5 mA (500 microamperes). Leakage current can be measured by any one of three methods. 1. A commercial leakage tester, such as the Simpson 229 or RCA WT-540A. Follow the manufacturers' instructions to use these instruments. A battery-operated AC milliammeter. The Data Precision 245 digital multimeter is suitable for this job. Measuring the voltage drop across a resistor by means of a VOM or battery-operated A