Toshiba eS 232-282 free download

File name DP-2840_PR_EN_0000.pdf

PC BOARD REPAIR MANUAL MULTIFUNCTIONAL DIGITAL SYSTEMS e-STUDIO202L/232/282 File No. RME05000700 R051221A2300-TTEC Ver00_2006-01 © 2006 TOSHIBA TEC CORPORATION All rights reserved Under the copyright laws, this manual cannot be reproduced in any form without prior written permission of TOSHIBA TEC CORPORATION. No patent liability is assumed, however, with respect to the use of the information contained herein. GENERAL PRECAUTIONS REGARDING THE SERVICE FOR e-STUDIO202L/232/282 SERIES The installation and service should be done by a qualified service technician. 1) Transportation/Installation - When transporting/installing the equipment, employ two persons and be sure to hold the posi- tions as shown in the figure. The equipment is quite heavy and weighs approximately 75 kg (165.34 lb.) therefore pay full attention when handling it. - Be sure not to hold the movable parts or units (e.g. the control panel, ADU or RADF) when trans- porting the equipment. - Be sure to use a dedicated outlet with AC 110 V / 13.2 A, 115 V or 127 V / 12 A, 220-240 V or 240 V / 8 A for its power source. - The equipment must be grounded for safety. - Select a suitable place for installation. Avoid excessive heat, high humidity, dust, vibration and direct sunlight. - Provide proper ventilation since the equipment emits a slight amount of ozone. - To insure adequate working space for the copying operation, keep a minimum clearance of 80 cm (32") on the left, 80 cm (32") on the right and 10 cm (4") on the rear. - The equipment shall be installed near the socket outlet and shall be accessible. - Be sure to fix and plug in the power cable securely after the installation so that no one trips over it. 05/11 2) General Precautions at Service - Be sure to turn the power OFF and unplug the power cable during service (except for the service should be done with the power turned ON). - Unplug the power cable and clean the area around the prongs of the plug and socket outlet once a year or more. A fire may occur when dust lies on this area. - When the parts are disassembled, reassembly is the reverse of disassembly unless otherwise noted in this manual or other related documents. Be careful not to install small parts such as screws, washers, pins, E-rings, star washers in the wrong places. - Basically, the equipment should not be operated with any parts removed or disassembled. - The PC board must be stored in an anti-electrostatic bag and handled carefully using a wristband since the ICs on it may be damaged due to static electricity. Caution: Before using the wristband, unplug the power cable of the equipment and make sure that there are no charged objects which are not insulated in the vicini