Philips p22-24 free download

File name p22-24.pdf

22 105S2 CM23 GSIII Electrical Adjustments 9 Go to cover page 0. General 3.Monitor the following auxiliary voltages. When carry-out the electrical settings in many cases a video signal SOURCE ACROSS C2153 and GRN +183.0V +/- 1.5 VDC must be applied to the monitor. A computer with : SOURCE ACROSS C2156 +81.0V +/- 0.5 VDC. SOURCE ACROSS C2164 +6.2V +/- 0.3 VDC. - ATI GPT-1600 (4822 397 10065), Mach 64 (up to 107kHz) SOURCE ACROSS C2158 +12.7V +/- 0.5 VDC. SOURCE ACROSS C2162 - 12.7V +/- 0.5 VDC. are used as the video signal source. The signal patterns are selected from the "service test software" package, see user guide 4822 727 4. General conditions for alignment 21046 (GPT-1600). 4.1 During all alignments, supply a distortion free AC mains voltage to set via an isolating transformer with low internal impedance. 0.1 This monitor has 6 factory-preset modes as below. 4.2 Align in pre-warmed condition, at least 30 minutes warm-up with 720 x 400 31.5 kHz/70 Hz nominal picture brightness. 640 x 480 31.47 kHz/60 Hz 4.3 Purity, geometry and subsequent alignments should be carried 640 x 480 43.3 kHz/85 Hz out in magnetic cage with correct magnetic field. 800 x 600 46.9 kHz/75 Hz 800 x 600 53.67 kHz/85 Hz Northern hemisphere : H=0, V=450 mG, Z=0 1024x768 60.0 kHz/75 Hz Southern hemisphere : H=0, V=-500 mG, Z=0 Equatorial Support : H=0, V=0 mG, Z=0 12 factory-preload modes as below 640 x 350 31.5 kHz/70 Hz 832 x 624 49.7 kHz/74.5 Hz 4.4 All voltages are to be measured or applied with respect to ground. 640 x 350 37.9 kHz/85 Hz 1024 x 768 56.5 kHz/70 Hz Note: Do not use heatsink as ground. 640 x 480 37.5 kHz/75 Hz 1280 x 960 60 kHz/60 Hz 4.5 Adjust brightness controls to center position except for contrast 640 x 480 37.9 kHz/72.8 Hz 800 x 600 48.1 kHz/72Hz control which should be set to MAX. 800 x 600 37.9 kHz/60 Hz 640 x 480 5.06kHz/100Hz 720 x 400 37.9 kHz/85 Hz 1024 x 768 48.3kHz/60Hz 5. To access factory mode: 0.2 Wi