Philips p16-19(EDID) free download

File name p16-19(EDID).pdf

16 105S2 CM23 GSIII DDC Instructions 9 Go to cover page 1. General 3. Pin assignment DDC Data Re-programming A. 15-pin D-Sub Connector In case the main EEPROM with Software DDC which store all factory settings were replaced because a defect,repaired monitor the serial numbers have to be re-programmed. It is advised to re-soldered the main EEPROM from the old board onto The 15-pin D-sub connector (male) of the signal cable the new board if circuit board have been replaced, in this case the DDC on the 3rd row for DDC feature : data does not need to be re-programmed. Additional information Additional information about DDC (Display Data Channel) may be obtained from Video Electronics Standards Association (VESA). Extended Display Identification Data(EDID) information may be also 1 5 obtained from VESA. 6 10 11 15 DDC EDID structure For the monitor : Standard Version 3.0 Structure Version 1.2 2. System and equipment requirements 1. An i486 (or above) personal computer or compatible. 2. Microsoft operation system Windows 95/98. Assignment Pin No. Assignment Pin No. 3. EDID301.EXE program (3138 106 10103) shown as Fig. 1 4. Software DDC Alignment kits (4822 310 11184) shown as Fig. 2. 1 Red video input 9 No pin The kit contents: a. Alignment box x1 2 Green video input 10 Logic ground b. Printer cable x1 Blue video input Identification output - 3 11 c. D-Sub cable x1 Connected to pin 10 4 Identification output - Connected to pin 10 12 Serial data line(SDA) Note: The EDID301.EXE (Release Version 1.55,)is a windows- based program, which cannot be run in MS-DOS. 5 Ground 13 H.Sync